Welcome to YLOAN.COM
yloan.com » Sportboats » How To Operate A Boat Davit
Sportboats Motors Recreation Sports Baseball Cycling Fishing Football Golf Martial-Arts Running Soccer Swimming Tennis Basketball Volleyball Squash Badminton racing Bowling Climbing Dance Gymnastics Handball Skiing

How To Operate A Boat Davit

The article below details step by step how to properly and safely operate a boat davit (crane)

. A davit can be used to lift a tender, dinghy, jet-ski, kayak, scooter, bicycle, etc. Never use a davit to lift people.

The steps below provide safe instruction for the operation of a hydraulic and manual davit. The how-to videos for these steps can be viewed on You Tube or on the UMT Marine website.

Step 1: Check the area around the davit and make sure it is clear.

Step 2: Remove the tie-downs from the pad-eye to release the davit boom.


Step 3: Check the condition of the hook.

Step 4: Connect the remote control to the davit.

Step 5: Turn the power on (breaker or switch).

Note: Remote Controls- your remote will depend on the type of davit you have.

Two Button- Operates Cable

Four Button- Operates Cable and Boom

Six Button- Full Hydraulic with Rotation

Step 6: The top buttons of the remote control the boom. To move the boom up- press the left button. To move the boom down- press the right button.

Step 7: The center buttons of the remote control the rotation. To move the boom left- press the left button. To move the boom to the right- press the right button.

Step 8: The bottom buttons operate the cable. To move the cable up- press the left button. To move the cable down- press the right button.

Step 9: When the davit is not in use, be sure to put the davit in the storage position.

Step 10: Turn the breaker off.

How to secure your hydraulic davit in the storage position

Step 1: Using the remote control bring up the davit cable

Step 2: Sweep the davit to pad-eye (Boom should be in up position)

Step 3: Move the boom down to the lowest position

Step 4: Turn the power off

Step 5: Use the tie-Down to secure the davit in the storage position by attaching it to the pad-eye

Step 6: Turn the turnbuckle so that the davit does not move during travel

Step 7: Remove the remote control

How to operate your manual davit

Warning: Davit is only for use with your dinghy (tender), Jet-ski, Scooter, Bicycle, etc.

Never use the davit to lift people

Step 1: Check the area around the davit and make sure it is clear.

Step 2: Open the inspection plate on the side of the boom and pull off the cable from the davit, making sure the cable is out.

Step 3: Turn the Power On (brake or switch)

Step 4: Move the cable down just a little so that you can take the hook out from the pad-eye

Note: The cable should never be loose

Step 5: Check the condition of the hook

Step 6: The remote control for 12 or 24 volt manual davits usually have two buttons for the cable- To move the cable up-press the left button. To move the cable down- press the right button.

Step 7: The remote control for 110 volt manual davits have a run button and an up / down button. Press the desired position and then press the run button.

Step 8: The extension has three positions. To use the extension:

Locate the pin on the end of the boom. Remove the pin and bring the cable down a little. Now you can manually sweep the extension to desired position and put the pin back in.

Step 9: To lift the boom

Take out the big pin

Lift the boom to desired position (2 options) and slide the pin back into position

Step 10: To rotate the davit

Manually move davit, left or right

Step 11: When your davit is not in use, secure the davit in the storage position

Step 12: Turn the breaker off

How to secure your UMT manual davit in the storage position

Step 1: Bring the cable up with about 1 inch left at the end

Step 2: Remove the big pin

Step 3: Put the boom in the down position and replace the pin in the storage position

Step 4: Remove the small pin on the extension boom

Step 5: Press the cable button on the remote control- the extension boom will go inside the boom

Step 6: Replace the small pin once the extension is fully inside the boom

Step 7: Sweep the davit to the pad-eye

Step 8: Attach the hook from the davit to the pad-eye

Step 9: Stretch a bit of the cable up so that the davit does not move during travel


Step 10: Turn the power off

Step 11: Remove the remote control or place it back inside the boom

How-to videos for this article can be viewed on YouTube by searching for how to operate a hydraulic davit and how to operate a manual davit.

by: Kelly Bradley
The Leather Passport Holder For Every Traveler Why Brace Mouthguards Must Be Worn For Sports Boat Building With Wooden Boat Blueprints Sports Supplements Can Help Men And Women Achieve Their Fitness Goals Selecting Sports Supplements With Care Are Boat Building Kits The Key To Plain Sailing When Building Your Own Boat? Boat Accidents Sportcraft Treadmill A Great Investment For Individuals In Their Health Top 10 Women In Sports "sports League" Build A Bear Bedding For Boys Outdoor sport is a nice way to improve mood Cruise Vacations: An Overview For First Time Cruisers Sportgrip Edge For Iphone 4: Sporty Never Looked This Good!
print
www.yloan.com guest:  register | login | search IP(216.73.216.35) California / Anaheim Processed in 0.026617 second(s), 7 queries , Gzip enabled , discuz 5.5 through PHP 8.3.9 , debug code: 114 , 4772, 40,
How To Operate A Boat Davit Anaheim