How to configure PPP on a Cisco router using the Cisco SDM

This article will show you how to configure PPP (Point-to-Point Protocol) using Cisco

SDM in order to enable communication between two routers connected through a serial link. This tutorial includes how to enable PPP encapsulation, and configure CHAP authentication. This article is designed for CCNA students, network engineers, and anyone looking to configure PPP using Cisco SDM (Cisco SDM is part of the CCNA syllabus).

The Point-to-Point Protocol (PPP) provides a standard method for transporting multi-protocol datagrams between two peers. PPP is comprised of three main components:

A method for encapsulating multi-protocol datagrams.

A Link Control Protocol (LCP) for establishing, configuring, and testing the data-link connection.

A family of Network Control Protocols (NCPs) for establishing and configuring different network-layer protocols.

Follow these steps in order to configure PPP on a serial interface using Cisco SDM:

Step 1: Open Cisco SDM.

Step 2: Click Configure in order to start Configuration.

Step 3: In the tasks bar, click Interfaces and Connections.

Step 4: Select the Serial (PPP, HDLC, or Frame Relay) option, and then click Create New Connection.

Step 5: Click Next.

Step 6: In the Available Interfaces drop-down list, select the interface to configure, and then click Next.

Step 7: Choose PPP as the encapsulation type, and click Next.

Step 8: Enter the IP address and the subnet mask for your serial interface, and then click Next.

Step 9: Choose Default Static Route if you want to make the Router on the other end of the PPP link your default gateway. If not, simply click Next.

Step 10: Click Finish, and then click OK.

How to configure PPP on a Cisco router using the Cisco SDM

By: CCNA Writer

POST COMMENT

Айти Представит Систему Слежения За Объектами И Систему Управления Иб На Московской Конференции Cisco Expo-2010 Cisco Представит Новое Подразделение Компании На Московской Конференции Cisco Expo-2010 Учебный Центр «Фаст Лейн» Примет Участие В Конференции Cisco Expo-2010 Cisco Завершила Процесс Приобретения Компании Arch Rock Ccna - Configuring Ccna Dynamic Dhcp On A Cisco Router Part 2 Ccna - Configuring Cisco Switched Vlans Cisco 642-741 certification test Cisco Вывела На Рынок Новое Семейство Видеокамер Flip Говорит И Показывает Cisco Cisco Ucs На Платформе Bmc Blade Logic Elisa Получила Статус Cisco Select Certified Partner Cisco 642-384 Demo Cisco Расширила Список Мобильных Устройств, Поддерживаемых Клиентским Программным Средством Информационной Безопасности