Installing Weatherstripping on a Door

Weatherstripping is usually used to seal the doors and windows of the house

. This will keep the rain and other elements out of the home. However, weatherstripping is also used to prevent the energy loss in case of heating and air conditioning by keeping the interior air inside. With time this weatherstripping becomes lose or damage due to multiple factors. Having a new and efficient weatherstripping is necessary for many reasons.

Many types of door weathstripping is available in the market, you need the best which suits your requirements. Some of the best qualities are felt, plastic V-strip, adhesive foam and reinforced vinyl seal. Among these reinforced vinyl seal is the best and is widely used.

Required Items

Following items are required to replace or fix the weatherstripping on a door:

- Hacksaw

- 3-piece reinforced vinyl weatherstripping kit

- Screwdriver

- Tape measure

- Utility knife

Directions

1. First of all you have to measure the vertical height of the door jamb. For this, close the door and measure the height from top of the jamb to the verge of the doorstep.

2. Once you have taken the measure, transfer it onto the metal piece of weatherstripping. Make sure you have located the contoured part of vinyl weatherstripping pieces properly, that part is specially designed to fit against the header piece of the weatherstripping. Use the opposite end for cutting.

3. Now cut the metal piece or strip with hacksaw at the marked spot. Using utility knife cut the vinyl tube in accordance with the metal strip.

4. After cutting the metal strip and vinyl tube, take the piece of vinyl tube and placed it firmly against the door and the jamb. Take a metal strip and fix it to the jamb with the help of screws. Fasten the screws properly. Don't over-tight the screws, once you feel the screws wrap up tightly stop fastening. Over tightening can give dent to metal strip. So be careful.

5. Now repeat the same process with the axle (hinge) side of the door jamb.

6. You are done with vertical part of the door; now start working for horizontal part of the door jamb. Take the necessary measurements of the horizontal width of the door jamb.

7. For metal strip to perfectly hold the door surface, proper measurement is very necessary. Apply the measurement you have just taken to the metal strip and modify the strip accordingly.

8. Cut the marked ends of the metal strip off at both ends with hacksaw. Take the vinyl tube and cut it with utility knife of same length as of metal strip.

9. Follow the Step 4 to install the weatherstripping on the horizontal width of the door jamb.

Installing Weatherstripping on a Door

By: Tauqeer Ul Hassan

POST COMMENT

Use a Wall Clock to Decorate Your Home Interior Diet to lower Cholesterol and Triglyceride Getting A Home Improvement Loan 5 Boku Benefits Of A Work At Home Gig 13 Benefits of A Home Based Opportunity Necessity Of Spray Foam Insulation Best Work At Home eBooks With Resell Rights A Walkthrough Guide Of Home Loans Acute Consideration & Knowledge Needed To Buy Port Washington Homes for Sales Peace of mind: Blackheath Estate Agents Usage With Maximium Benefits For Home Loans A Useful Review for the Roll Top Bedroom Home Office Writing Desk Some Of The Ten Things To Consider When Looking For A Homeowner Loan