Laptop Keyboard Repair - Replacement

Laptop Keyboard Repair - Replacement

Laptop Keyboard Repair - Replacement

Before you consider laptop keyboard repair, you may want to look into replacement instead. It is potentially something you could do yourself saving you lots of money. For example, if you happen to own a Compaq Presario, replacing the keyboard is really easy and can be done in just a few minutes. Follow these quick step-by-step instructions to this laptop keyboard repair tutorial.

First, gather your tools. All you'll need is a screw driver and a credit card. Yes, I did say credit card, not to purchase anything but to use as a tool to pry up the bezel.

Next turn off your computer and then turn it upside down and remove the two screws from the bottom of the computer case. These two screws hold down the bezel which is the bar located right above the "F" keys. After you turn the computer right side up again, take your credit card and wedge it between the keyboard and the bezel and gently pry the bezel up and out of the slots. You might hear a bit of popping noise but that is normal.

Now you will have the top side of the keyboard exposed. Take hold of the keyboard at the side toward the screen and gently lift it up and pull it away from the touch-pad end while slowly flipping it over. You will see the keyboard data ribbon. To remove this ribbon, you need to unlock the little plastic connector that is holding it in place. Do so by pushing down toward the system board and then pull up on the corners. The piece comes straight up, not out and the ribbon will be released. With the ribbon now free, carefully pull the ribbon out of the connector and remove it along with the entire keyboard.

Finally you are ready to install the new keyboard. Take the new keyboard in your hands and place it upside down so you have easy access to the ribbon. Do not twist the ribbon as this could damage it. Put the ribbon end into the connector and lock it in place by gently pushing down on it. It only goes into the connector one way so there is no confusion about that. Now flip the keyboard over so it is right side up and match the pegs with the slots and push it in place. It is now time to replace the bezel with the two screws. Turn over the computer and replace the two screws you removed from the bottom. Now power on your computer and see if it works. If the keyboard is not working, turn off the computer and check that you properly installed the ribbon and try, try again.

POST COMMENT

Fake Windows Activation screen Removal - How To Remove Fake Windows Activation screen Easily From Your PC Bad Credit Business Loan - Repair Your Credit Report Quickly and Legally and Get Back Into Business Choose Between The Soft Wood Or Hard Wood Windows For Your Home Benefits Of Installing Timber Windows For Your Home Entourage Repair When You Cannot Add or Edit Contacts in Address Book Take Good Care Of Traditional Wooden Windows To Maintain Their Beauty Xbox 360 Repair Myths: Find Out The Truth Sliding Sash Windows: Various Elements Of These Handy Fixtures Windows Xp Problems Why You Should Hire Computer Repair Services In Reno Cleveland Replacement Windows And Doors How To Clean Windows Xp Registry Today Looking For The Windows Xp Registry Fix?