Learning How To Weld 4130 Chrome Moly (part 2)

Monday, May 14, 2012

Monday, May 14, 2012. Pittsburgh, PA. In Part 1 of How to Weld Chrome Moly, Mr. TIG went over some basic information on 4130 Chrome Moly covering how to get started, when to use 4130 and other beginner welding tips. In Part 2, we venture into some more difficult practices that are used in more advanced welding projects.

In the beginning of the segment (0:46) Wyatt talks about some of the benefits of using 4130 Chrome Moly, Including strength to weight ratio and what type of welding projects it is generally used for.

As usual, Mr. TIG then answers a few of the more frequent questions that he receives during the week:

Can you gas weld 4130?

Yes you can gas weld 4130. I prefer TIG Welding, because it is faster and has more control, but if youre still gas welding, it can do a great job.

Do you need to pre-heat all 4130 Chrome Moly?

No, you do not. With 100 thousandths wall thickness or less, you do not need to preheat.

Do you need to have an oversized weld to make sure it is good?

The answer to that is no. This part has a wall thickness of about 62 thousandths, the fillet size is about 100-120 thousandths and that is plenty. When you evaluate the cross section of the amount of linear inches of weld, it is more than enough strength. Typically in this case you will not have to put a second weld pass on, but always add filler material.

What filler material should I use?

There are 3 recommended filler materials that you can choose.

1.ER80SD2

2.ER70S2

3.ER70S6

After going through these questions, Wyatt shows you a prepped piece of 4130 tubing and an un-prepped piece and goes over the advantages of cleaning your project surface.

At 5:00 Wyatt puts on his safety gears and prepares to show you how to weld a piece of 4130 tubing. As you see the weld demonstration, Mr. TIGs animated helper comes in to tell you that When reaching a fillet area in a cluster, you may require additional amperage to obtain the correct puddle size.

Todd Clouser is the Marketing and Social Media Specialist for Weld.com, Your Connection to the Universe of Welding. With a broad knowledge of social media and emerging marketing technologies, he is determined to create a resource in Weld.com that proves to be an unrivaled asset to the industry.

Contact Information:

161 Hillpointe Drive

Canonsburg, PA 15317

E-mail: tclouser@weld.com

Phone: 724-820-1880

by: david wayne

POST COMMENT

Learning How To Weld: Transformer Or Inverter? Variations Of Terms Of A Contract Comparative Approach Welding Tips From Mr. Tig: Choosing A Welding Helmet Welding Tips From Mr. Tig: Tig Torches (part 1) Defeat Insomnia In A Delicious Way With Chamomile Tea Dog Training In Brisbane: Handling Your Pet The Right Way The Perfect Internal Doors Using Timber In Diy Projects Who Is The Creep In The Creepers? Top 4 Places To Holiday In Mandurah Ground-breaking Insight Into The Bus Charter Ohio Industry Feel The Vivacity Of Popular Highlights By Taking Flights To Shanghai Square Foot Gardening Rules!