, then its better to change as early as possible because it will create many problems for you in future. It is also important to turn the ignition lock into specified position before removing it. This article will tell you how to change or repair your ignition lock? All you need is internal circlip pliers, external circlip pliers, and fine nosed pliers. If you do not have these tools then it will be really hard for you to do this. These tools are very important and essential. After you purchase a new ignition lock just get ready with your tools to change it. Direction and position of ignition lock is very important you must take care of it during installing it.
First of all you have to remove the old ignition lock, remove the screws and hold the upper steering column shroud and remove it. After removing it arrange the wafers and spacers according to the number of your key. Place the barrel end on to the castellated end and hold with your fingers. Do not try to lubricate the wafers because it can cause premature failure. If you are installing the new lock then make sure that it will operate perfectly in your car. There are many types of ignition locks but most of them are really hard to find. There are very small numbers of store that contain all kinds of ignition lock. Because there are a lot of models of cars and trucks on the road so most of the shop owners do not have ignition locks for each and every car. Therefore you have to search a lot for it. The ignition lock contains two major components one is lock cylinder and the other one is electrical portion that can supply power to electrical components like lights, electrical window and wind shield, that electrical portion of the lock also provide the power to start the motor that starts the engine of the vehicle. The lock is basically an anti-theft device; it provides the security to your car. It will not start until you use the correct ignition key. It is not possible to turn the steering wheel. It is really good thing and it can prevent your car being theft too. It is among one of those items that can provide your car a perfect security.
If you want to replace the lock then the trim panels that are around the steering wheel are first removed. After that the tamper- proof that is attached with the lock to the steering column is removed then.