Old computer CD drive use and maintenance tips
Old computer CD drive use and maintenance tips
Tray easy to get stuck in the first aid measures
Open the drive enclosure, the power principle of observing the warehouse pallets: pallet out of position by a power roller by the belt, the drive is connected to another with the tray on the gear wheel, drive tray out of warehouse.
Under normal circumstances, the old optical drive tray is not the main reason warehouse: drive belt aging, always slipping, can provide the impetus for greatly reduced. There are a secondary reason: to stabilize the disc, a small tray above the main motor is magnetic, when disc Jincang, this little tray of magnetic iron will and positioning were small stuck together from the top and bottom plate film to enhance the stability, but there is no disc storage, the magnetic tray is a small and close to attract small Dell Vostro 1500 battery iron plates together. Because the disc tray in the magnetic small iron plates, trays and between (the middle of an oval tray openings, providing a small tray and pull the small of the iron space), so in order to make the tray out of position and power to provide the thrust roller is greater than the magnetic small tray of small iron plates of the suction, a small tray with a small force of magnetic separation of iron plates, trays to be able to come out. Understand the reasons, the treatment is more easy.
This problem can be resolved in three aspects, the most recommended is the third method.
1. Weakened magnetic method
This method is to find ways to weaken the magnetic small iron plates, trays and between the suction, so that the skin does not need to provide a great impetus hoop can launch it into the tray. Operation of law may be considered in a small iron plates affixed stickers on the paper, reduced mutual attraction, so that you can achieve the purpose of the tray out of position. However, this approach is that: When the disc rotates at high speed, stability is not very good due to the disc, it will affect the drive's life.
2. Increase the friction force method
This method is to increase the drive belt on the two plastic rollers friction, consider the operation method is to use medical tape or double-sided adhesive tape wrapped around the plastic rollers on the look, not too thick. However, after experiments, such an approach can only be maintained with a short time, the wound will fall off tape, we can find themselves a better alternative.
3. Replacement Belt Law
This method is to replace the new belt, increasing the IBM thinkpad t43 battery power transfer. But not easy to get the right belt, the solution is to find a short inner tube bicycle repair shop, evenly carefully cut with scissors 1 to 1.5 mm wide rubber band ring, to replace the original belt, the specific use of which kinds of waste tire inner tube models toughness should make a decision, you can also go to the scene holding the existing belt gestures.
Qiao demolition drive
Although no in-depth demolition drive skills to speak of, but still should sum up the experience to introduce to you two.
1. Dismantle the front panel
The first step in demolition drive is sure to open the drive's front panel, so as to facilitate the drive apart. With a toothpick or a straightened paper clip into the emergency eject hole (on the front panel), push a little harder inside, you can launch the drive tray, then removed the front panel and then much easier. Remove the front panel, the tray can be removed other parts of a reset.
2. A positive start
The second experience is the drive I found that most are relatively easy from the front cover removed, remove the screws on the front cover can open all the shell, the mechanical drive systems and chassis to complete the circuit in front of the show. But there are some brands of CD-ROM front cover there is no screw to split from the bottom, but after removing the bottom four screws, just only the bottom of the shell removed, the above and still move around the enclosure can not afford, just to see to the circuit base plate, but could not find on the optical drive was a removable screw. Further observation, that the rest of the metal casing the place for the screws down to the bottom of the mechanical systems inside the circuit, but also found that the mechanical parts and circuit board plug-in connection is used, it is easy to think the next time we Removing the step is to force the board opened, in fact, this is wrong, the correct removal method is: a close look at the four screw holes, each screw hole is drilled from the circuit board, metal casing drilling overlap consists in PCB hole drilling and metal shell has a black plastic below the elastic snap (functional properties similar to that used on the motherboard plastic buckle), because it is black, and possession of a place in the light not shine, so easily ignored. So when we drive in the demolition of such surface phenomena will inevitably arise because of some misleading. The remaining operations would not I have to say, the use of forceps can get an elbow.
CD ROM drive to change the old
Change the old acer aspire 3810t battery CD ROM drive only difficulty is how to add a play button, because most of the old optical drive speed, only to "close / open the" doors of the operation. In fact, this problem is simple, but it is easier said than hands-on renovation is too much trouble. Method is to open the old drive enclosure, according to the panel's "Close / Open" button in the line to board, you will see it next to the system microprocessor connected to a five-pin socket, to the market to buy a CD machine with the key board and the five-pin socket connects to enjoy CD music. Specific production time if necessary, can also open a new drive as a reference.
Never Picking a Bad Battery for Your Laptop Laptop Service Training How to effectively send online text message from computer Surprising Things You Can Do On Your Home Computer How To Go About Buying Laptop Mains Chargers Kegel8 Discount Code - Saving Money On These Popular Pelvic Floor Toners The Best Way To Fix Virus Issues On Your Computer Pointers to Picking the Best Postcard Printer Diet Programs And Menus - The Shapiro Diet Printing Flyers for Advertisement Commercial Printing Vancouver Epson AcuLaser M2300D Toner Review PC Backup System Programs