If you have a brand new Macbook or notebook computer, you probably want to keep it in the best condition possible. Why invest in an expensive soft or hardcover case, when you can protect your laptop surface from scratches and stains with your own homemade vinyl cover. This craft requires the use of a very sharp knife, so do not try unless you are experienced with using X-acto knives or similar cutting tools.
1.Shut your computer off. Clean the surface of the computer with a damp cloth.
2.Cut a piece of vinyl slightly larger than the keyboard panel of the computer. Lay the vinyl over the entire surface, including the keyboard. Smooth or press out air bubbles. Wrap the vinyl edges securely around the sides of the computer.(macbook skins)
3.Cut around the outside border of the keyboard letters. Rub the vinyl so you see the imprint of the keys. Use a ruler if it is too difficult to follow the keys. Also cut out the trackpad and around the plastic joint that connects the screen. Remove cut vinyl pieces. Practice extreme caution and do not press the blade too hard, as it can ruin the keyboard.
4.Cut around the edges of the entire bottom panel. This will give the vinyl a very clean cut appearance. Peel the extra vinyl from the sides. Rub the edges with your fingers or the end of a paintbrush.
5.Cover the screen portion of the laptop in vinyl. Cut out the screen and a small hole for the camera.
6.Close laptop. Apply vinyl sheet on the cover and wrap around the edges. Smooth out any air bubbles. Trim the sides of the vinyl to make a clean cut along the edges.
7.Turn laptop over. Place a vinyl sheet over the panel and smooth out edges. Trim the vinyl so that edges are smooth. Cut around the air vent. Peel off cut vinyl pieces.