Raymond Mill Introduction
raymond mill:
raymond mill:
Comparing with ball mill, raymond mill features high efficiency, low power consumption, small size, a one-time small investment and widely used in barite,
calcite, potash feldspar, talcum, marble, limestone, dolomite, fluorite, lime, activated clay, activated carbon, bentonite, kaolin, cement, phosphate rock,
gypsum, glass, insulation materials, etc whose mohs hardness is not greater than 9.3 and humidity is below 6%. Raymond Mill is mainly consist of the
milling system, analysis system and dust removal system.
Raymond mill Installation :
Pre-installation preparation :
1. Before
Raymond mill has not yet installed on site, should be properly kept. Exposed surfaces shall be coated with anti-rust oil, and avoid the sun and rain
to prevent rusting water body, to establish a maintenance system.
2. Plant and infrastructure should have sufficient height and size of the installation location. The base of raymond mill should be poured with standard
cement and steel. After pouring cement a good foundation, you must have the maintenance period of 15 days.
3. should be accompanied by 2 ~ 3 tons lifting tools for installation and maintenance with Raymond mill.
4. After using raymond mill more than 6 months, clean and inspect the central axis of the host system, transmission device, roller device, analysis of oil
pools. After that add enough to cope with the various components of lubricants.
Raymond mill Operation Flow :
Before starting,should check whether all the maintenance doors closed tight, check the crusher jaw plate gap is in line with the feed grain size, adjusting
the analytical engine speed should reach approximate finished size requirements. The final start the machine as the order.
1. start bucket elevator; 2. activate the jaw crusher; 3. when there are material silo, start analysis machines;4 to start the air blower;5. start the
Raymond mill, at the same time start electromagnetic vibrating feeder.
shut down the raymond mill machine in the following order:
1. first close the vibrating feeder to feed material;2. about one minute later stop the host;3. blowing the net residual powder then do the cessation of
sub-blowers;4. the final close analyzer.
by: stone crusher
Massage For Retinoblastoma Wrapping Your Head Around Your Lms Ways to Quicken Your Degree Completion Each charge before the battery discharge is not necessary, but also harmful Going Through the Procedure of Ffxiv Gil How To Transition Into An Assisted Living Situation Breathtaking Sight Seeing In Adelaide Tout Sur Les Abdos Free Is Strep Throat Contagious? How To Build Valuable Backlinks 4 Vital Mistakes For Investors To Avoid 4 Items That Should Be The Focus Of All Investors? What Are Bridesmaid Duties