Remote Monitoring Center City Fire Fire Safety Measures
City fire remote monitoring center is a computer doing work and expensive computer system
, a fire breaks out, a huge economic losses, and information, information and data destruction will be to the management, monitoring system adverse impact.
One, the possibility of fire danger
1. Interior decoration needs a lot of wood, plywood and plastic panels fuel, ventilation, use of polystyrene foam pipe insulation and other combustible materials can lead to lower the fire resistance of buildings.
2. Centers and more electrical equipment, electrical circuit complexity, if the selection of inappropriate or does not meet installation requirements, can short circuit, overload, etc. caused fires.
3. Take time and continuous work computer, if the failure was caused by insulation breakdown, short circuit or high impedance power supply components such as heat and fire poor contact.
4. Staff to wear polyester, eye-lun, chloride fiber and other clothing or PVC slippers, static electricity sparks.
5. Used items are not timely processing of combustible or flammable cleaners cleaning equipment and floors, fire source to the fire.
2, fire prevention measures 1. Remote monitoring center center should be set away from the distribution of harmful gas and the production, storage of corrosive substances and flammable substances, or for upper hand in the direction of its annual construction. Should not be located in the drop-mined areas, mines, and silt, sand layer, formation faults, seismic activity zone and low-lying wet areas, but also to avoid a strong electromagnetic field, strong vibration source and place strong noise sources. Ensure that the natural environment must be clean, convenient transportation, electricity, adequate water source.
2. Fire resistance level of the building should not be less than two, should reach a vital part. Five or more rooms, basements and on lower or adjacent inflammable and explosive dangerous shall not be installed on the computer room. Remote monitoring center and other rooms to use a firewall separating closed and decoration to use non-combustible or Flame Retardant . Information storage devices to be installed in a separate room, data frame and information counters should be non-combustible materials. Main remote monitoring center should more than two exit doors should open outwards.
3. Air-conditioning system should be linked with the alarm control system control. Duct and insulation materials, anechoic materials and adhesives shall be used for non-combustible or flame retardant materials. Heater fan switch and the switch have to chain control. Duct through remote monitoring center wall and floor office should be located damper, the maximum working temperature of not more than 25 degrees. Individual support and hanger can be attached to other methods to prevent duct deformation.
4. Cable shaft and pipe shafts in through the floor, you must use the fire resistance of not less than 1 hour without burning body partition to separate cable channels through the remote monitoring centers in the walls of office, have set the fire resistance of not less than 0. 75 hours does not burn body partitions, wall cable should be set of metal pipes, seamless application of non-combustible material block. Cable channel to take moisture and rats and measures, and stratified laying signal cable, power cable and ground, etc.. Cable connection with the cabinet to be strong. To create a self-powered uninterruptible power supply system or systems and near the center of remote monitoring devices set up emergency power. Computer system power supply line, not connected with the air conditioning system load changes, motor and other electrical equipment, and do a good job shielding ground. Fire power equipment, distribution lines should be worn for surface metal tube, dark dressing should be laid in the non-combustible structures. Strong, weak lines, cable shaft should be set separately, but also addition of glass or other noncombustible materials and the protective shield, the introduction of high-power lamps line should wear ceramic pipes, asbestos insulation glass and other non-combustible material for protection. Electrical equipment installation and maintenance, change lines and temporary use of line, should be consistent Electrical Fire Requirements. Battery room should be set by the external walls. Enhance ventilation, its electrical equipment should be explosion-proof.
5. Outside the remote monitoring center should be good Lightning Facilities.
by:pretty
Radio Crane Remote Control Systems Safety Boots For Safety In The Workplace Canada Media Directory, Canada News Papers, Canada Television, Canada Radio How2r1 A High Performance Hi-gain Outdoor Wireless 300n With Dual Radio Smart Repeater First Aid Instruction For Better Family Safety Circuit Workouts An Explanation Is Health And Safety In The Office Truly Important? Making Safety In Your Home A Priority Garage Door Repairs - How Important Are Safety Cables? Pool safety should always be front of mind Scoring System for Plain Chest Radiographs in Patients with Asbestos Related Disease Electronic Organizing: Manage Your Medicine All About Circuit Breakers