Shelby Glhs
1986
1986
The '1986 Shelby GLH-S' was a modified Dodge Omni GLH, with all changes made at the Shelby factory. They were retitled as Shelby Automobiles cars sold at select Dodge dealerships. GLH stood for "Goes Like Hell" and GLHS stood for Goes Like Hell Som'more (Seriously!). Just 500 were made.
All cars came from Dodge painted single stage black (no clear coat). Dash plaques used a 3-digit serial numbering system (as only 500 were made).
The Turbo I engine was modified with pre-production pieces from what would become the Turbo II inline-four engine. These changes included an intercooler and other changes to produce 175hp (130kW) and a flat 175ftlbf (237Nm) torque curve. Not included were any of the durability changes to the short block (forged crank, full floating pin, stouter connecting rods, etc.) of the 1987 Chrysler Turbo II engine. Luckily, the Shelby engines have proved to be reliable even without the durability enhancements of the production Turbo II. Performance was impressive, with just 6.5s needed for 060mph (97km/h) and 14.8s for the quarter mile (402m) run. Top speed was 130mph (209km/h).
Shelby Automobiles received the first T-2 induction pieces (prior to Dodge/Chrysler), and installed them on the 500 GLH cars that shipped to the Wittier factory. Engine mods. included: New T-2 fuel rail, T-2 injectors, wiring harness, larger throttle body, bigger turbo, tuned intake & exhaust manifolds, intercooler/rad. & fan assemblies, induction hoses, T-2 airbox, GLHS specific logic module, CS-Shelby-CS windshield decal, & tape graphics pkg. Interestingly, there was a Dodge emblem left on in production. A black/yellow overlay sticker was placed at the bottom of the speedometer to read to 135mph (217km/h). A Momo leather wrapped shifter knob, Izumi leather wrapped steering wheel, & shift pattern sticker were also installed. A Use only Mobil 1 in your GLHS plaque was affixed to the front of the standard production valve cover.
The primary differences between the Shelby engine and the Chrysler Turbo II engine are the torque: Shelby's unique engine computer shaved the torque to save the stock Omni transaxle, Chrysler Turbo II engines had 200lbft (270Nm) of torque; the trimetal bearings, forged crank and extra oil passages weren't present; and the wiring harness is a conglomeration of original Turbo I, with splicings for the heated oxygen sensor.
All-in-all this was a very formidable car, especially on short tracks. In SCCA Solo competition, it was never allowed a place in the stock categories because it failed to meet the required 1000 unit a year production quota.
1987
The '1987 Charger GLHS' was based on the 1987 Shelby Turbo Charger. Shelby Automobiles purchased the last 1000 of these & they were shipped to the Whittier factory for modification. Shelby modified the Charger using the same pieces as the 1986 GLHS with some changes. These included a non EGR turbo, Shelby valve cover, wider Shelby windshield decal (no CS logos), different & more extensive tape graphics package, no reference to Dodge on the outer body, black/white speedo overlay, a 4-digit serial numbering system on the dash plaque, wider Mobil 1 plaque installed on the radiator support, & Centurian II wheels.
Notes:
The 1987 Charger GLHS uses 1986 electronics & fault codes.
The dash plaque on 1987 GLHS Chargers read "Shelby Automobiles Inc", "Carroll Shelby" autograph and "Charger GLH-S ####".
Some early (low s/n) Charger GLHS's came with a shortened 1986 GLHS winshield decal (CS logos removed).
All 1986 & 1987 GLHS's were first run using conventional oil for engine break-in, then filled with Mobil 1 oil. All transaxles came filled with 5-30W engine oil.
All GLHSs came from Dodge in single stage black (no clearcoat).
There is at least one odd ball that was painted by a dealership because the car wouldn't sell. The dealer had red paint added over the black. This vehicle is owned by the California Shelby Dodge Club president. All had the same options which included a leather-wrapped steering wheel and gearshift knob, air conditioning, sunroof, non-armrest center console and KONI struts/shocks on all four corners. There was also an allowance made for the 85mph (140km/h) speedometer in the form of a sticker which extended the range of the speedometer to an indicated 125mph (200km/h). By the time the speedometer had wrapped fully around to the "5mph" mark, the car would have been going at 135 mph (217km/h). There was also a new version of the Shelby "Centurion" wheel that looked very similar to the Centurion wheels on the 1986 Omni GLHS, but had the "blades" turning in the opposite direction. These are commonly known as Centurion II wheels.
Accessories
One of the most popular performance upgrades for both of these vehicles is the MOPAR Performance Stage II Computer (Logic Module). This increased the boost to 14.7 psi under wide-open throttle.
External links
Wikimedia Commons has media related to: Shelby GLHS
http://www.shelbyregistry.com/ Register your Shelby
Front-Runners.net - Carroll's Own GLHS
Categories: Shelby vehicles | Front wheel drive vehicles | Subcompact cars | Hatchbacks | 1980s automobiles
by: gaga
Just Why is Laughing Great? What Is The Function Of Transmission Poles? Wow Mage Leveling & Quest Guide Landscaping With Artificial Grass Window Box Contest Onions, Sweet Onions Staying Organized Qufu City, Shandong Efforts To Develop "low Carbon" Farm Machinery - Agricultural What To Expect From Massage Courses Selecting The Best Fats Burner 2011 For The Best Results Are Your Ready To Take The Real EA Test? Your Ghillie Suit Can be Different Making The Most Out Of Your Time