Concrete is a construction material which is quite strong in compression but usually weak in tension
. With this feature, this material easily bears the compressive forces or loads. The reinforcements play a crucial role in the bonding of this material so that it may take tensile strengths. Most household and commercial place makes use this construction in beams and slabs. Defects or damages may occur after casting the concrete. This may be bending, honey combs or leakages from water. The process of repairing the defects takes little time and the concrete made good. To know little more about repairing of concrete work you can read the article given below.
The repair of concrete work is usually done in dry weather. The reason is that this work demands some time to be dried completely and for achieving the required strength. One needs to cure it on a regular basis for at least one week once the correction is almost done. An engineer always suggests some directions in case if the defects are appearing as cracks on structural concrete. The recommendations given by a structural engineer are very useful after assessing the cracks on the concrete. Well, people can easily complete the task of repairing of general concrete defects at their own household projects.
Check all the required materials when going to repair concrete. These materials may be cement, sand and chippings. These days the usage of chippings is so common because the size of chippings in relation to ballast or coarse aggregate. Another most important reason of their heavy usage is that it is very easy to set them in small holes like honey comb defects. The usage of sand can be seen on concrete structures. The most common defect is the honey comb. When the casting is done, concrete with air pockets is appeared on the surfaces.
In order to remove the loose materials, the process of hacking the concrete thoroughly is done. Water is given on the hollow form. Now, the mixture of chippings and cement is prepared in order to form a good consistency. The raked out areas are then flourished with this paste. This process is done in layers before the filling of the void. The process of the curing it continues for at least one week and finally the required and best possible finish is applied to the concrete surface to get the best possible results in the concrete work.