The Influence Of Crusher Working Parameters

Crusher's types and specifications, rotational speed and schedule

, ore discharging mouth size and nip angle have influence on crushing.

Using different types of crushers to do the same crushing work will get different production capacity. In the condition that there are same feedings and the same product particle size, gyratory crusher productivity is 2-3 times of the jaw crusher productivity. Among the similar Jaw Crushers, the single toggle Jaw Crusher has the productivity that is 20%-30% higher than double toggle Jaw Crusher productivity. Even if there are equipments with the same type, if the specification and size are increased, the productivity will be also increased. High rotate speed will lead the productivity decreasing and the crusher will be blocked, especially the medium or fine Cone Crusher. High rotate speed also will make the materials jump by centrifugal force so that the crushing chamber will be blocked. For these reasons, increasing rotate speed is not used for increasing the productivity. Crusher with high specification, its stroke adjustment of jaw moving or cone moving is also large. Processing hard and brittle ores should use small stroke and processing soft and sticky ores should use large stroke. Large discharge opening will have large productivity but the reduction ratio will be reduced and the crushing action will also be reduced. In the discharge opening is too large, much of the materials will be discharged without being crushed. When the discharge opening is small, the reduction ratio is higher but the productivity is too low. So when the crusher is working, the both reduction ratio and productivity should be considered and it is better not to pursue a one-sided only.

The size of crusher discharge opening decides the nip angle of the crusher. The nip angle of jaw crusher is to say the inclined angle between moving jaw plate and stationary jaw plate when vising the ores. During the crushing process, the nip angle should guarantee the ores in crushing chamber will not jump out. So there must be enough friction between ores and jaw plate, which can prevent the ores will be squeezed out.

Classifier : http://www.crusher-export.com/classifier.htm

Sand maker : http://www.best-crushers.com/sandmaker.htm

by: jocelyn

POST COMMENT

All About Mba Salaries Personal Income Is Quite Tough Challenge For Everyone The Reason For Ball Mill Occupying The Market New Dr. Martens Lineup For Fall 2012 Cash Today: Money With Easy Formal Process The Basic Natural Skin Care Products Notes On Pre Construction Condos Schengen Visa Get It First Time How Can Wsi Franchise Be Beneficial For You? Get To Know About Candle Making Starter Kits How To Choose A Perfect Catamaran Power Boat Many Benefits Of Organic Bedsheets Edevoir, Correction De Devoirs En Ligne