The Simplest Comprehensive Method Of Led Tube Light Setup

The Setting up LED tube lights is a great approach to saving money on electricity

and bring out potentially hazardous fluorescent lights from home or office. However, a large amount LED tube lights on the market today can not just be directly installed in an existing fluorescent fixture. You need to make some simple corrections to the fixture to properly mount the bulbs. The good thing is, that installing a LED tube light in a pre-existing fluorescent fixture is pretty simple.

Fluorescent fixtures are designed to support a specific styles and dimension of fluorescent tube. A fluorescent tube is integrated with a fluorescent lighting system which consists of two or three main components: (1) the fluorescent lamp (fluorescent bulb or tube), (2) the ballast, and (3) the starter machine. In addition, the unit for a tube lamp contains a lamp holder and a switch. Depending on the particular fluorescent lighting system, the starter may be a replaceable component, a starter may not be required, or the starter performance may be worked into the ballast. The starting operation may also rely on the concrete design of the bulb. To retrofit a fluorescent light furnishing to support a LED tube light, the ballast (and the starter if a single one is present) must be disengaged.

Make sure that the LED replacement tube lights are the right size for the fixture. Also, always remember that when servicing a fluorescent fixture or lamp for any reason, electrical power to the whole fixture should be detached.

You will need a few simple tools, such as a wire cutter and wire stripper (often built into the same tool), a set of pliers, a screwdriver, and some wire nuts for reconnecting the wires once you have taken out the ballast.

Once the old bulbs are pulled from the lamp holders and the power to the fixture is turned off, you will also have to remove the reflector that is located behind the lights and provides a casing for the wiring and ballast that are situated behind it. Typically, it is fairly easy to remove the reflector or cover, but if it is not apparent how to achieve this, you should consult the manual from the bulb manufacturer.

If the furnishing has an electronic ballast, you just need to remove that and then wire the power right for the lamp handles, completing one electrical connection for each fixture. This is hassle-free, and customarily you can use the existing wire in the fixture and then just add more some wire nuts. If you have an older fixture with a magnetic ballast and starter, you will need to remove or open the starter and eliminate or short the permanent magnetic ballast.

Once the ballast (and starter, if one was found) have been detached and the wires reconnected, to accomplish an electrical connection for each bulb, swap out the reflector or cover over the electrical wires and the location where the ballast was situated, and the LED tube bulbs can be inserted in the end sockets. Not like fluorescent bulbs that do not effectively have a top or bottom, a LED tube light should have an obvious top and bottom, using metallic heatsink located on the backside of the cylinder and the LEDs noticeable under a lens on the side which will be aimed towards the spot to be highlighted. Place the hood back on the bulb (if there was one) and start up the electricity. Turn on the switch and if you have done all the things properly, you must have a good or better brightness using approximately half the energy and last for as long as 50,000 hours or more.

by: John Reid

POST COMMENT

Healing Scars On The Skin The Way To Estimate How Much Solar Power You Might Need Welches Material Aus Hemd Und Hose Ist In Mode? Ist Es Jeans? Hulu Gives Up Selling The Company Shaper Cutters: Woodworking Versitility Precision Tools How Do Wind Turbines Do The Job? How Does Solar Power Function? Prevention Of Heart Diseases With Various Methods Importance Of Having A Qualified Plumber Drain Cleaning Hayward: Let Professionals Handle It Just What Is Solar Power? How Athletes Can Prevent Jumper's Knee Polyproof Construction Chemicals