Time Division Multiplexing Layer Concept

Time Division Multiplexing Layer Concept

Time Division Multiplexing Layer Concept

Time Division Multiplexing

Bell Laboratories invented time-division multiplexing (TDM) to maximize the amount of voice traffic carried over a medium. Before multiplexing, each telephone call required its own physical link. This was an expensive and unscalable solution. TDM divides the bandwidth of a single link into separate channels or time slots. TDM transmits two or more channels over the same link by allocating a different time interval (time slot) for the transmission of each channel. In effect, the channels take turns using the link.

Full Post:

Time Division Multiplexing Layer Concept.

Time Division Multiplexing Layer Concept.

TDM is a physical layer concept. It has no regard for the nature of the information that is being multiplexed onto the output channel. TDM is independent of the Layer 2 protocol that has been used by the input channels.

TDM can be explained by an analogy to highway traffic. To transport traffic from four roads to another city, you can send all the traffic on one lane if the feeding roads are equally serviced and the traffic is synchronized. So, if each of the four roads puts a car onto the main highway every four seconds, the highway gets a car at the rate of one each second. As long as the speed of all the cars is synchronized, there is no collision. At the destination, the reverse happens and the cars are taken off the highway and fed to the local roads by the same synchronous mechanism.

This is the principle used in synchronous TDM when sending data over a link. TDM increases the capacity of the transmission link by slicing time into smaller intervals so that the link carries the bits from multiple input sources, effectively increasing the number of bits transmitted per second. With TDM, the transmitter and the receiver both know exactly which signal is being sent.

In our example, a multiplexer (MUX) at the transmitter accepts three separate signals. The MUX breaks each signal into segments. The MUX puts each segment into a single channel by inserting each segment into a timeslot.

A MUX at the receiving end reassembles the TDM stream into the three separate data streams based only on the timing of the arrival of each bit. A technique called bit interleaving keeps track of the number and sequence of the bits from each specific transmission so that they can be quickly and efficiently reassembled into their original form upon receipt. Byte interleaving performs the same functions, but because there are eight bits in each byte, the process needs a bigger or longer time slot.

POST COMMENT

The Power of having a Vision Board Optometry Coding: Save 'foggy Vision' For Secondary Dx 2011, Provisional Export Of Rare Earth Mining Rate Of 15% Just Illuminate Dark Vision By Ir Illuminators Vision Of Christianity Creative Brief Document Template – Bring Direction to Your Vision Lasik Laser Vision Correction The Power of Vision Choosing Clear Glasses for Clear Vision Why Is It Necessary To Understand The Provisions Of Chapter 13? Laser Vision Correction with Lasik Natural healing methods of bad vision Improve Your Vision Without Glasses