Troubleshooting stop 0x0000007b Error In Windows 2000

Error Stop 0x0000007B occurs quite often in Windows system creating lots of trouble for the users

. In this article you will find troubleshooting methods for "Stop 0x0000007B" error messages that may occur on your Microsoft Windows 2000-based computer.

Consider a practical situation where you receive an error message that is similar to the following on a blue screen on your Windows 2000-based computer:

***STOP 0x0000007B (parameter1, parameter2, parameter3, parameter4)

INACCESSIBLE_BOOT_DEVICE

Reasons behind this error

The "Stop 0x0000007B" error message is a Windows 2000 Executive character-mode Stop error message. There could be numerous reasons behind this. It may indicate that either a failure occurred during input/output (I/O) system initialization when the driver for the boot device initializes the device that Microsoft Windows is trying to start from, or that the file system did not initialize because it did not recognize the data that is stored on the boot device. Following situations can lead to this error message:

1. If Windows is installed on an unsupported disk or small computer system interface (SCSI) controller.

2. After the installation of a new SCSI adapter or disk controller.

3. When the disk was repartitioned with the system partition.

This article describes both general and specific troubleshooting steps that you can use when you receive this error message on your Windows 2000-based computer.

Resolution

To resolve this error issue and to access all files and folders once again, you are suggested to abide by the following steps.

a. You may receive a Stop 0x0000007B error message if your computer is infected with a boot sector virus. Use an antivirus program to check your computer for viruses. Additionally, check any floppy disks for viruses before you use them again.

b. If you recently added new hardware, remove the new hardware or reconfigure it so that it does not conflict with the resources of any other installed controllers.

c. Use the Last Known Good Configuration feature. Using the Last Known Good Configuration feature may resolve the problem if you recently installed a device driver that is incompatible with your boot controller.

d. Use an Emergency Repair Disk (ERD). If you have an ERD, use it to troubleshoot the problem. You can use the emergency repair process to repair the system files, the partition boot sector, and the startup environment.

However, if you are not successful in getting the solution and urgently need to access files and folders, then take help of hard disk recovery software. Recovering deleted, lost, inaccessible files and folders has never been so easy with hard disk recovery software. It scans the entire hard drive sector by sector to trace files that could be recovered.

by: websoft

POST COMMENT

Restore Windows XP Registry - Effective Methods Can Windows 7 Compete with iOS and Android Easy And Advantageous Windows 7 Upgradation Performing Windows 7 Computer Recovery When It Is Unable To Start How To Decide Upon The Sashes For Your Windows? The Best Option For Windows 7 Upgrade Operating System Not Found Error In Windows The Remarkable Convenience of Windows Hosting Software Development: Offshore Trend has Opened-up New Windows of Opportunities for All The True Benefit of Registry Cleaners - What a Registry Cleaner Really Does For Your System Power Tool Parts And Repair Diagnosis Top-dog.org Defamation Of Character Internet Reputation Repair Toyota repair in Birmingham