Protect your life, business, property and home from fire hazards. The fire can be caused by your gas leakage in your house. It is difficult to detect gas leakage in your house since some gasses do not have a specific odor even odorless.
The leakage of your gas installation can be caused by:* The gas leakage on hose.* Gas stove that is damaged.* Leaks in the seal / rubber tube.* Forgot to close stove appropriately after using it.* Leaks in tubes in a collision / rust.* Rat bites* Installation / installation that is not properlyHow to Use This gas detector:1). Turn on the gas detector life position (ON).2). After you switch it on, the detector will need approximately 3 minutes to become standby/normal conditions then both green and red light will be turned on. After 3 minutes the red lamps will be turned off, the only lamps that turned on is green lamp.How to install gas detector:1. You should install the detector close to the floor around 30cm to 2 meters of the LPG tube or a possible source of leakage of the LPG. Gas detectors can be used only on LPG. It cannot be used to detect fire and smoke in the open room.2. Do not install this detector in wet areas, too humid, dusty surface due to the close of LPG sensors.3. do not install this device on a hot place above 50 degrees Celsius4. If the alarm of the gas detector is on, do not turn on the lights and any other electrical appliances.5. Smoking is prohibited while checking the detector. It would be better if you open the door and the window so the gas will flow out of the room. Make a sign on the place where the leakage is occurred (hose, stoves, or regulator tube)http://www.articlesbase.com/home-improvement-articles/how-to-install-gas-detector-3617161.html