subject: How To Finish A Pine Cupboard Door [print this page] Cupboard door is made of pine wood joint, soft, inexpensive to look nice in the kitchen colleague. Pine, lightweight and easy to work with. Make sure the stain new pine doors to protect them from nicks and humidity, and the application of regularly leak long-term results.
The completion of the benefits
When you are finished with stain or high-gloss polyurethane, pine takes on a sheen of brilliant. However, different parts of the wood may absorb different spots, so the application requires some patience and attention to detail.
Start by sanding
Pine boards is very easy to sand, but they are also easy to damage. Your best bet for this type of wood for the use of paper 180 stones in random orbital sander. Sander quickly set the lowest possible, and not to add pressure. Let the tool do all the work during the provision of guidance only.
Once completed, use 220 grit paper and sand on the one hand, and power sander could leave now marks a small scuff in the wood.
Deal with scratches
In case you scratch the door, pine, and use a brush to apply a small amount of water to the affected area. Coverage of iron washing with a soft cloth and heat in the region. Will lead to an increase in wood grain on a point of zero.
Clean
Once you have sandy section, and use a soft cloth, or vacuum Tech with a soft brush attachment to clean any remaining dust.
The application of sealer
Because different parts of the same pine board have a tendency to absorb the stain in different ways, it is best to apply a coat of sealer before adding a disgrace. This will stop the stain to absorb too deep.
Once the plug is dry, go over it with sand paper grit 220. Clean and then again with a piece of cloth or a vacuum.
And stain the door of the cupboard Pine
The application of gel stain with a brush of foam. Work in sections of about 1 square feet, and wipe off any excess. Once you have the entire region, and wait for a period of not less than 5 hours and stain to dry before applying another coat. Repeat this process until you achieve the desired appearance.
The application of topcoat
Pine look better when it is finished with a coating that runs thin satin varnish. Should be for one or two coats be enough to make it shine. If there is any area of raw and sand them very lightly wounded, with some 220 grit sand paper.
