subject: How To Bullnose Granite [print this page] If you want to learn how to bullnose granite, you should be aware that it can be a difficult task. In addition, it is possible that this task requires a great deal of special equipment. In general, it is not a good idea to perform this task yourself. However, if you have access to appropriate tools and materials, and there is no reason that you can not bullnose granite of your own.
Tools and materials needed
* Diamond grinding wheel bullnose
* Diamond grinding disc
* Mask Ventilator
* Sunglasses
* Masking tape
* Measuring tape
* A clean cloth
* Water
Step 1 - Setting Up
The establishment of granite to work on that would be extremely difficult. Finding enough space to work on the granite can be difficult enough, but when you factor's weight in the formula, there are hardly any occasion on which to work surfaces. If you are working on granite, which has not been installed yet, you'll have to get creative. One possible solution is to use Sawhorses as a multi-surface granite set on your job.
If you already installed your granite, you're going to bullnose on the spot, and this is also fine. However, you will have to isolate your work area to avoid spreading dust everywhere in the granite.
Step 2 - Measurement of Angles
To begin, measure out of granite you will be at work. Out a tape measure and find out your display. Do this in several locations to increase your accuracy. Once you have done so, and measure the line from end to end, parallel to the edge will be working on. The distance from the edge of the base which is based on measuring the degree of curve you want on your granite. Finally, use masking tape to celebrate what you have measured.
Step 2 - Use of grinding wheel
Before they really start to grind your granite down, and put on your mask and protective goggles. This important step, and you will be producing a lot of dust, granite and you do not want to breathe or get on your eyes.
To start, grind the edge of your granite with bullnose your grinding wheel. Do not worry about taking off a lot of granite, especially on your first try. Focus on the grinding evenly too. It will certainly need to go over the edge of the special section of granite several times, once until you have more than that I went once, and start again. It will take probably several runs before you can continue.
Step 3 - use a CD-grind
Once and clearly constituted a bullnose as a result of your grinding, you should switch to disc grind. You will need multiple types of disk to this stage, ranging from 100 to 1500 grit sand. Start with a disc that contains less grit and work your way up and examine your work frequently. In the intervals between each use, wipe out your granite with a damp cloth. Again, focus on the grind evenly.
Once you work your way up to the top disc grit, go over your work one final time with a CD gravel 3500.
