subject: Setting Up Printer Driver To Default Stencilmark [print this page] Setting Up Printer Driver to Default STENCILMARK
These were the setting details for making laser engraver as default in Printer driver.
1. Insert disc and follow the installation instructions. Once the installation is complete and youve restarted your computer continue to the next step.
2. Open Printers and Faxes by clicking on the start button and selecting the Control Panel.
3. Single click on the Epson LQ-1 170 ESC/P2 printer driver.
4. Select File> Server Properties> Forms tab
5. Check Create new form.
6. Give your form a name, ex.: StencilMark 3x2.
7. Paper Size: Set width to stencil width inside glue lines. Width 5 in., Height (Length) - 2.00 in., Left: 1.50 in. (only SM3000 imprinter), then click Save Form. (Note: You need to add 2 inches to the width in order to have the stencil line up properly. So if your width is 3 inches you should enter 5 inches in the width box.)
8. Repeat steps until you have entered all the desired forms you need. Additional forms can be entered at any time.
9. Click Ports tab and select the port your printer is connected to. It will usually be LPT1 or USB001. (Note: Not all USB ports are activated when you start your computer. Run a Test Print from your print driver properties before calling for techsupport.)
10. If your imprinter does not respond you have a system problem unrelated to StencilMark TM. Consult your PC or Windows manual or contact your IT personnel.
11. If you have a disabled port consult your PC orWindows manual or contact your IT personnel.
12. Click Drivers tab. You should see a driver called Epson LQ-1170 ESC/P2. Click on this so it is highlighted.
13. Exit Printers and Faxes.
The Printer Driver set-up is now complete. I hope it would have been very helpful to all of us!
