subject: Nuoya New Brick Machine Maintenance Instructions [print this page] Brick making machine (concrete brick machine, Burning-free brick) maintenance and maintenance instructions
Device power main line should be used for more than 25 mm 2 16 mm 2 or more aluminum or copper. Normal operation of equipment when the input voltage: high voltage 380V-410V, voltage 330V-360V, reliable grounding device must be installed to ensure the safety of operators, such as the installation of grounding devices are not required, resulting in personal injury or death shall not be responsible for our factory.
Oil pump motor is stopped or turning Bie difficult, resulting in burning motor, because the total pressure regulator device
Valve (under the large nut splitter) regulator is too large. (Total pressure regulator should be adjusted gradually smaller, until the electrical work is not very difficult when the rotation is better)
Vibrators is less vibration, a brick or a brick loose long period because of lower die pressure regulation under the pressure too much; (under too much pressure regulator module, the pressure of vibration suppression of the vibrators should be cylinder on the next ejector tubing pressure corresponding to the gradual transfer of small regulators alone, until the machine's vibration force to fully play out)
Resulting in mold, balance arm, and host the site appears to Weld or damage due to mold under pressure, under pressure regulator is too small; (under pressure, under pressure regulator model is too small, the pressure can not be locked under the mold, resulting in Taiwan Mold and vibration impact force is too large, on the whole set of equipment damaged part that is too large, should be on the pipeline under the ejector cylinder pressure corresponding to the regulators alone Adjust gradually until the machine's vibration force was stabilized to reduce the damage on the machine)
When the tile surface produced loose brick, bricks are breaking phenomenon, or when the mold off bricks with the lower die on its own mention because of the pressure head pressure is too low; (the pressure head pressure too low will result in brick positioning loose tile surface should be on the tubing on the pressure head cylinder pressure corresponding to gradually adjust its own regulators large Filed under model, while in the gently moving the wrench on the model, making the pressure head tank to maintain a certain pressure Under the model can be maintained in the slabs together with the increase in mold, thereby reducing the damage rate of a brick)
When producing brick tiles found among the belly because the pressure head on the cylinder pressure is too high, or the vibration time is too short, the model failed to place pressure; (if found damaged bricks high, irregular, care model should pay attention to light when raised, or check the humidity and the ratio of aggregate, such as too wet, is shown as a brick when the brick will be cut out a lot of water, such as too dry, is shown as brick deformed, can not a brick)
If regulators fail, because of the pressure regulating valve spring damage or failure; (should be replaced the same type of pressure spring)
Cylinder leakage, such as fuel tank was found because of loss of cylinder sealing body seal; (should replace the corresponding type of seal)
More emphasis on the use of equipment maintenance and maintenance in order to reduce maintenance, and thus more qualified products.
Operation of the specific issues customers should carefully read the instructions, read after the implementation of the action, to the brick making machine (block machine, Burning-free brick) smooth and comfortable to use, give full play to the superiority of equipment, and to extend its service life.
