subject: The right way to install a lock on roller garage doors [print this page] How one can install a lock on roller garage doors
Often when people change their roller garage doors it's because the lock has busted, but this needn't be the case. Changing a lock on roller garage doors is rather simple and may be accomplished simply be adhering to these few quick steps.
1.Roller garage doors have to be closed before beginning any work on them. Use vice grips on the garage door tracks to ensure it remains closed for the entire duration.
All roller garage doors have a pin which acts to secure the lock handle to the lock shaft. In order to do this you need to place a nail over the pin and give it a tiny tap. That should reveal a piece of the pin, permitting you to remove it fully with a set of pliers.
2.You can now pull the inside handle off the shaft and as such pull the lock bars off the shaft also. On roller garage doors, the lock bars are 2 straight pieces going from the lock to each side of the door.
Both the lock bars are joined on a plate which then mounts above the lock shaft.
3.Over the shaft is a deadbolt lock, where you'll see four screws. Unscrew these to disconnect the deadbolt.
Next, in order to take away the lock assembly from the door unscrew the two screws that'll be securing it. Then move to the exterior of the roller garage door and grab the lock.
4.Replacing locks in roller garage doors will need you to go ahead and take existing lock into ahome improvement store and choose a matching lock that has the same length in between the 2 mounting holes that will be in your garage door.
For the following step inchanging the locks in roller garage doors you'll need the help of your friend. Tell them to slide the brand new lock through the door and hold itin position. Using the two screws that areleft over, fasten the brand new lock from in the garage.
5.The new deadbolt lock now must be installed on the roller garage door. The external door handle includes a thin bar which extends through the roller garage door and must be repositioned back into the deadbolt.
Roller garage doors require you to place the lock bar back through the guides on each side of the door. On roller garage doors, these guidesin addition act as brackets for the lock bars to lie in once the door is unlocked. Finally put the lock bar plate on the lock shaft.
6.The last step when swapping the locks on roller garage doors would be to place the brand new interior lock handle back onto the shaft and lining up the hole for that pin to fall back in place. Once again tap the pin employing a nail to fix it into place so that the pin is lined up with the handle.
