subject: Hot Tub Cover And Spa Covers - Measuring For A New Cover [print this page] Spa producers are regularly modifying their spas and molds. It won't work to basically submit the make and design with the hot package. Most hot tub cover producers do have templates for hundreds with the most well-known spas, but your measured dimensions are probably the most precise and make certain a proper fit for your hot tub cover!
In case you like the way your hot tub cover fits, measure the hot tub cover you might be replacing. However, if your existing insure is warped or damaged in any way, we advise you measure the hot package itself. Hot tub covers possess a tendency to shrink above time, so measuring the hot package may be the finest way to have the right measurements along with a insure that fits perfectly.
Measure the length and width, at the widest point of with the acrylic lip with the hot package. Be certain to measure for the outside edge so the insure will lie across the complete lip with the package. Round up each and every measurement for the nearest 50 percent inch. Being added secure, add 1 inch for the dimension to give a 50 percent inch margin on each and every side
Most producers will offer spa shapes with dimension lines on the illustration. Be certain to note where the measurement lines start and end for the spa shape you selected, then measure those dimensions.
The common rule is: if a insure is just a tiny too big, it's going to fit fine. If it's just a tiny too little, it won't be a hot tub cover.
Air buttons, head rests, control panels, handles, etc. that happen to be raised above the lip call for custom cutouts and recesses. A detailed explanation will be needed and an further charge is normally essential.
