subject: Steps To Make your Own Case Insulation [print this page] Many people in California buy custom cases for different accessories that they use, like cameras and laptops. But the inside of that case is not insulated. In the given below article, you will be told how you can cut inside foam so that you can customize your cases. In California spray foam is starting to get really popular with each passing day. It is a very simple process and you need to follow the given below steps.
The very basic thing is to arrange the stuff in the right order. Take out the layers of the case that you want to customize. After this is done put them on a plane surface. Then put all the equipment that you are going to use on the foam that you got with the case. Keep redistributing until you get a fitting arrangement.
The important thing is to leave enough space for each and every type of equipment. The lighter stuff should be separated and kept away from the heavier stuff.
Next thing that you need to do is to mark the foam. Get a chalk and mark an outline on the foam which you have obtained. You need to be very precise while drawing the outline of the various items. Once this is done, remove the items from there and draw another outline, which is a little inside the original outline. When you are making this new outline, you should also smoothen out any wavy lines that may have been accidently made. Only move on to the next step when you are completely satisfied.
When you are through with the above step, you have to get a knife and cut the foam. Generally, it is tough to cut with a normal knife, so it is recommended to use an electrical carving knife. If you cannot get hold of such a knife, a knife which has an 8" blade must be used. Keep the foam on the table, and keep the knife at a vertical position while you are cutting the foam. If you are using an electrical knife, do not try to saw through the foam. Instead let the knife cut through the foam itself. When you square a corner, end a cut there and start from the other direction ending where you ended the previous cut.
Just a little few steps and you can easily make yourself spray foam insulation for your case.
