subject: Xbox 360 System 3 Red Flashing Light Repair Instructions - Resolving The Fault By Yourself [print this page] There are numerous Xbox 360 3 red light repair instructions that you can locate on the World wide web. Although the most obvious thing to do when you encounter a problem with your Xbox 360 games console is to make use of your manufacturer warranty, there will be folks that favor solving faults such as this on their own.
The three red flashing lights in your Xbox system, better referred to as the red ring of death, may be the result of overheating, dirty GPU and CPU chips, insufficient main power supply and a host of additional possible internal troubles. To mend this by yourself, here's a single set of instructions you can follow:
1. Switch off your Xbox and extract the hard drive. Remove the top and bottom air vent by pulling them both off.
2. For people with an Xbox 360 console unlocking key, utilize it to free the locking mechanism so you can remove the two halves of the Xbox system. If you don't possess the unlocking key, make use of a flat head screwdriver.
3. Lift the tabs found on the front of your console to remove the side of the equipment. Unscrew the various screws but observe where each goes to be able to put them back without difficulty after you've repaired your console.
4. Subsequent to removing the screws, take off the eject button then remove the other half of the case.
5. Remove the DVD drive and pull off the plastic casing at the rear of the unit, the one that covers the fans.
6. Leisurely remove the fans. After that, remove the white plastic located around the main power button. You will notice a number of screws on the circuit board. Remove those and pull the board out. It is possible to then remove the motherboard from the metal frame.
7. You will then see the X-shaped clamps, remove the clamps and then the two heat sinks connected to the clamps.
8. Getting a cotton bud or q-tip with arctic cleaner or alcohol, wipe the two processing chips and the heat sinks.
9. Coat the processor chips with thermal paste. Ensure that the thermal paste is evenly applied and that the quantity you use is not excessive or too little, simply enough to evenly coat the processor chips.
10. Wait 15 to 20 minutes prior to placing all components back again. Each action ought to be done with care and slowly to avoid damage to the games console.
These outlined Xbox 360 3 red light repair instructions are part of just one option to make your system work and get rid of the dreaded red ring of death. Now if the problem is something even more critical or has relates to damaged parts, then you will have to either take your console off to the manufacturer or buy a comprehensive repair guide for a better solution.
