subject: How to Implement a Barcode Project Successfully [print this page] The very competitive corporate world keeps facing novel challenges and in order to face them it is imperative to have access to information. The necessity for a greater store of information on services and products has created the need for makers of barcode labels to seek manners in which a greater quantity of information may be stored in barcodes that exist. This began the making of novel kinds of scanners of barcodes as well as barcodes that work in various kinds of hard situations. Novel barcodes may be brought into a company easily only when the proper situation is available. Proper environmental conditions are necessary for barcode labels and a mode of collection of data and way to review it. All this must be tested prior to the end of the barcode project. This makes a easy transition when the project is started.
Conditions to Test Prior to Selection of the Barcode Project
High and heat temperature level- Barcode labels are helped to stick on by possessing pressure sensitive tapes that are constructed of heat sensitive components. Heat weakens them ad the tape get thin and flows out which makes the label move. It is possible for high heat to ruin the image on the barcode and mess up the scan. Material is affected when there is continued exposure to hot conditions. Therefore check the heat and get the right barcode for the situation.
Lower and Cold Temperatures- Unique kinds of labels are needed for cold temperature. Under the situation that a label is stuck to items in room temperature having cold surface the label could possibly not get on there the right way. For these situations Freezer Grade Adhesive is available which may be utilized in F 10 degrees.
Bright Light is bad for the barcode scanner. On the occasion that a light rebounds from the surface it may cause a bad scanner performance. Therefore it is better for dull matt finish when the dearth of luster makes small of the reflection light intensity. The other choice is to utilize dim light in the room where the scan will happen or use overhang to protect scanner from the bright light.
Outdoor Material-Outdoor material that resists the outside environment can be hardier for barcode material. Included is polyester adhesive and acrylic adhesive. Repeated lamination is recommended to lengthen life span and potential for ultra violet screening.
Scratch Protection- The risk of scratch is large and metal labels may withstand the scratches. Scratch safe materials include kapton and Teflon and polymides.
Humidity and Moisture- Wet areas and moisture must be avoided so that labels may be protected by a laminated layer on top.
Solvents- solvents must be avoided since they weaken adhesive and stickiness.
Grease and oil- The entire area must be cleaned in order to be sure that there is no oil or grease on them because it will ruin the adhesive.
Chemicals and agents- Cleaning agents and chemicals must be removed because they also ruin the adhesive.
Label Surfaces- Be sure it is not placed on patterned surface since the adhesives wont bond there.
Scanning Requirement- Always keep view and distance in mind for the image to look good.
Barcode Symbols- The best results of all are 2D and RFID scanners. Anything else is not as good.
Barcode Density- The most recent scanners possess the ability to scan very small barcodes easily thanks to Quiet Zone Space which is necessary.
Verification of Barcode- In retail and warehouses verification methods are used
Professional Training- Staff must be properly trained so that there wont be any mistakes made with the barcode and information.
In order for a barcode project to succeed all these checks and balances must occur in order that there will be no major challenges with the accuracy of the implementation.
