subject: The Work of a Color Laser Printer [print this page] The Work of a Color Laser Printer The Work of a Color Laser Printer
There is no need to doubt that printer is certainly beneficial for printing documents with the best result. One of the best options of laser that available on the market today is presented by Xerox. As the brand name that has been popular for years, Xerox creates laser printer that uses xerographic printing process for printing an image onto the paper.
There are two types of laser printer which are monochrome and color laser printer. Monochrome laser printer uses only one toner in the printing process, while color laser printer uses three or four colors which are cyan, magenta, yellow and black. These colors are commonly known as CMY or CMYK. Each of these colors needs its own image so that it will take up three to four times as much memory as the monochrome printing.
If you still cannot find the idea about the work of color laser printer, the followings are going to give you some information that you can take a look. Just check out the information below to find what this printer can offer you so that you can be sure that this printer is a great investment for you.
In creating the image, the first process is to fill the imaging drum with the negative charge. Then, the charge needs to be exposed by using a laser, from the areas where the image is to be placed. When the image is exposed, it is developed to start. In the process of developing, the negative charged toner jumps onto the exposed sections of the drum. Then, the image is transferred to a piece of paper and it runs over the heated fuser drum where the toner is melted to the paper. Then, the drum is cleaned and the process can be started again.
Moreover, the printing process in most monochrome printers is done in tandem by using a small drum. While in the color laser printer, because it uses three or four toner, it cannot run in the tandem because it may cause misalignment of the color. For solving this problem, each step should be done individually by placing on the drum before fusing.
