subject: Stainless Steel Pipe Composition And Proportion Of Lotion [print this page] Stainless steel has excellent corrosion resistance and appearance, in recent years is widely used in food, chemical, paper industry, atomic power generation, shipbuilding installations of piping materials, parts, etc., used very widely. These stainless steel pipe after welding cutting, bending and welding process occurred in the dirty, rust and welding caused by weld marks not only affects the appearance and increase corrosion. Fluoride treatments are generally used nitric acid to wash the acid lotion, its drawback is that after cleaning stainless steel capillary pipe table.
The uneven surface will produce a black and spots Ukraine. Because the pickling of stainless steel pipe processed products but the final steps to complete. Therefore, the pros and cons related to the acid lotion processed their own value-added high or low. Therefore, some of the recent steel tube processing requirements.
Easy to operate and can use the balance of surface treatment, more importantly, can not damage the surface of stainless steel capillary pipe acid lotion.
Product Use
Introduction of foreign technology to produce, place a long time no corrosion, and rust removal acid material effect.
First, the performance characteristics:
1. The product is paste the object, at room temperature for stainless steel pipe welding and heat treatment weld cleaning of stainless steel after oxide removal.
2. The product viscosity and stability, can be easily coated on the upright and down the surface, simple operation.
3. Add pickling inhibitors, non-corrosive to stainless steel, not to hurt the skin.
4. Rinse in good treatment, as long as the water can simply go acid residue.
Second, the scope of application:
Treatment after welding stainless welding caused the black spots and the oxide coating and surface treatment.
Third, use:
1. With a brush or cloth dipped, or applied to the surface to deal with the weld, the coating thickness of 0.5 ~ 1mm.
2. Coating after 20 minutes scrub (low temperature oxide thick-skinned of the processing time may be extended).
3. Finally, wash with water.
Fourth, note:
1. This product is corrosive, accidental skin contact, rinse with clear water flow.
2. The product waste shall be discharged after treatment.
3. This product should be stored airtight in a cool ventilated place.
4. This product is only suitable for industrial use.
