subject: To Use Electric Winch [print this page] Of course, using the electric winch was started from the installation, because it is directly related to the subsequent steps and the use of electric winch effect.
Specific installation process is as follows:
1. Insert the remote control
2. Do not allow remote connections hanging.
3. Pull the noose, the noose with a remote control to open out a bit and then installed in the side of the rope electric winch hook.
4. Open the clutch. Note that we must open the hooks open the clutch later.
5. Hold the rope hook hands. Will pull the rope from the drum when the hook with one hand hold, so no matter how long the twisted Sola, will not not reach the hook.
6. The noose pulled pivot, the locking clutch.
Then there is a fixed fulcrum.
Regardless of what kind of electric winch, without security, pivot, you can not give full play to their potential. In other words, the fixed pivot is a crucial step when using the electric winch. When using the electric winch, but also a strap to connect the electric winch, the fulcrum and the noose hanging hook and U-shaped ears. If you do not have enough power electric winch with single drag heavy objects, you need to use the lane to enhance its efforts, this time also need a tight line pulley. Another point to note that when using the tree as the fulcrum, to use the widest part of the tape so that tape to the bark in Le destruction of trees, and be sure to tape the left and right ends of both sides were tied at the hanging ears, on both sides length to the same tape.
Then start dragging, electric winch to drag the specific steps:
1. First check drum.
2. If the noose emerge, should prevent it from swinging back and forth. If the rope snapped, and the rope lashing back and forth can be very dangerous. However, the risk can be avoided if the taut rope put a pad on the line.
3. Began to pull, twist Sola If your car, and you have to drive in the car, the best a man in the car to help you.
4. If the rope twisted together, and must bring it opened. Noose around the drum is easy to cross, or when one side becomes uneven. Therefore, pay close attention to its status.
5. When the car can move around, the drag is complete. Once back on flat land, to check the status of vehicles and lines.
6. The noose was curled. Tighten noose, carefully return it.
7. Finally put away the hook. When the noose only the last point, the electric winch hook tied to the side. Then roll up the remaining little rope to hook to suppress.
