subject: Recover Deleted Files After Ntfs.sys File Goes Missing Or Corrupt [print this page] The NTFS file systems are usually designed to be less prone to damage and corruption issues when compared to FAT or FAT32 file systems. However, corruption can occur anytime to any system. One common NTFS-related issue comprises of corruption of NTFS.sys file that might happen due to innumerable issues. If in case the ntfs.sys file goes corrupt or missing, it might result in windows system going into unbootable state and can make the partition inaccessible. You might repair or replace the file by using various methods using Recovery Console. But if it fails, then you will require a powerful and efficient recover deleted file tool.
For example, consider a situation when a user tries to run disk defragmenter on their Windows XP based hard disk which was formatted to NTFS file system. In such situations, the tool freezes and when you restart the system afterwards, your computer will fail to initiate. Additionally, it will display the following error message:
Windows could not start because the following file is missing or corrupt: System32DriversNtfs.sys
After the occurrence of this error message, you cannot access the disk partition. The major reason behind this issue is discussed further. NTFS file system has a driver file named ntfs.sys, which allows the windows computer to read/write data to NTFS partitions. The above problem results when this file becomes corrupt or goes missing while you run disk defragmenter.
In order to resolve the above mentioned issue, you have to repair or replace the ntfs.sys file in your system. To do this, you can utilize any of the methods given below:
1.Boot your computer using Windows XP installation to initiate Recovery Console with administrator log on. This way you can use command prompt to run the commands given below:
cd windowssystem32drivers
ren ntfs.sys ntfs.old
copy cd:i386
tfs.sys drive:windowssystem32drivers
Over here cd and drive are the drive letters of CD-ROM drive and primary partition
2.If in case this doesnt resolve your problem, then your problem might be a result of disk-related issue. Therefore, you can run chkdsk/r command from Recovery Console command prompt
3.If the problem persists, you must repair or reinstall the Windows installation on your system. In order to restore the deleted data after Windows reinstall, you can use the last valid backup.
