subject: How to Use and Maintenance of Inflatable Bouncers [print this page] How to Use and Maintenance of Inflatable Bouncers
1. The inflatables device flat on the ground. Smooth surface of the land surface or ground, can be directly stalls; with rubble and other sharp objects on the ground, need to pave the protective layer on the ground (such as the color of the cloth, tarpaulin, canvas, etc..)
2. Certified by a professional electrician technology according to the relevant provisions of safe use of electricity wiring, installation and maintenance.
3. Check the fan power and the use of the total, sub-cable match.
4. Instructions by using the blower fan. Check the fan is loose, turn the fan to check for smell, to determine the normal after the power test machine; use of three-phase fans, it is best to use off of protection, so as to avoid burn-off phase fan.
5. Start multi-turn turbines can be started, pending before a wind machine running 20-30 seconds and then start the next station.
6. Less leakage of new equipment, the initial period, only part of the mouth bar fans, soft and hard since, as the equipment level, and gradually all of the fan population Zhazhu.
7. The close of business should first turn off the power, then unlock the device fan port, to be stopped after the removal of fan blades, and 10 minutes before folding equipment.
Maintenance and Repair Method
1. To keep the product clean, wipe with water regularly.
2. To keep the product dry. Waterproof, moisture, mainly to protect the sutures. After rain or wet weather should always blowing cool, so dry.
3. Glue conditions: A. Air drying, B, the temperature at 20 degrees.
4. Glue method: A, the bar and be sticky sticky clean cloth, B, and to be sticky sticky cloth article to be uniform and thin coating, C, to be cool cloth to the white plastic surface again when the adhesive, and squeezed hard.
5. Children often rub wear the thread, stitch seam to be the new cement to protect the stitching. If the straps fall off to make up time.
6. Children less than a stitch foot, if a long time, too much eye of a needle hardness of cushion to bond.
7. If the toy longer useful life, part of the fabric pull-off wire, cement a timely manner, if necessary, after the first seam stick
8. Blower use and maintenance, please refer to with the blower belt use and maintenance methods.
Solve the real culprit rub means breaking inflatable bouncers
1. Take off your shoes to enter;
2. Check whether the child's clothes and pants zipper or keys, and so many, the proposed off pants with a zipper;
3. Wear socks into the (hot days, more difficult to achieve, it is recommended to buy a number of small socks).
Special treatment 1. To reduce equipment noise, noise enclosures can be added to the fan or the fan replaced with low-noise fan.
2. Problems in the equipment operating in the "instructions" can not find relevant content, please contact the manufacturer.
