subject: Code Complete, Toshiba Copier Maintenance - Toshiba Copiers, Maintenance Code - Silk Screen Printing [print this page] By 0 and 1 keys simultaneously to open the power panel lights all light up, press the clear / stop key to lift
Press the 0 and 2 keys to open the power plant into the aging method, showing AG, also lifted by 09 key
03 or 04 by pressing the power key to open the machine into the input / output test that shows CH, enter a different code can start the different components, such as 03-33 exposure lamp examination
Press the 0 and 6 keys to open the power force start "Fuser not heating"
Press the 0 and seven keys turn the power into the feeder automatic way of aging, showing AG, according to exit 09
By 03/04 key while turning on the power, access to input / output check the status display CH, out of 09 key by pressing
1 main motor ON11OFF 2 for roller clutch ON12OFF 3 positioning roller clutch ON13OFF 6 toner motor ON16OFF 7 cooling fan ON17OFF 10 P key by the total counter
20 scan Motors P key to move 50% of the then key 200% P
21 P key to move the lens motor by 50% in the P key by 200%
22 Mirror Motors P key to move 50% of the then key 200% P
31 Transfer Exports of P key ON then OFF key P
32 separate outputs and then press P key to P key OFF ON
33! badger profile control Su Margaret? Key to P key ON then OFF
34 pre-bias transfer and then press P key to P key OFF ON
40 on the motor box and then press P key to P key OFF ON
41 on the paper tray for the clutch and then press P key to P key OFF ON
43 cartons under the motor and then press P key to P key OFF ON
44 boxes for the next clutch of paper and then press P key to P key OFF ON
Above is testing the code, generally use only 03/040508, aging means running the machine empty.
1, replace the vector The same time by 05 and turn the power switch, panel displays AJ, type adjustment model No: Press Copy button to display the current value, to (automatically) adjust the value type changes, press the Insert key to modify the value into memory, press 3 + 4 copies -
0TD sensor automatically adjusts - Type 0, drums and keys by copying the work of Developer of about 2 minutes to change the panel shows the number of start automatically after a short stop to change the number displayed. -
Displayed value = 24 (2.4 0.5v), by inserting key into memory, according to exit ---------------- 09
---------------- Out of 05 self-diagnosis mode: type "09 "----------
Clear signal maintenance ------ The same time by 08 and turn the power switch, panel display AD, type adjustment model No: Press Copy button to display the current value, to (automatically) adjust the value type changes, press the Insert key to modify the value into memory, press 3 + 4 Copy ----
69 - PM (maintenance period) interval set - Range: 0 ~ 999,999 default value = 0 ----------
79 - the current PM counts show ---- Range: 0 ~ 999,999 default value = 0 ----
When 79 to 69 show the numerical values set the signal occurs when the maintenance and re-set the maintenance cycle will remove the maintenance signal ---------------- 08 set out self-diagnosis
