subject: Tips to Install a Motion Detector on a Light [print this page] Tips to Install a Motion Detector on a Light
The presence of motion detector plays an important role to give best security for your home so you need to consider its usage. In this case, you will know very well that installing this unit could be considered as an affordable way to improve your outdoor security. Commonly, this unit is completed with light fixtures that will support this unit for easy installation so you will know that it will be a great thing to consider. If you would like to install it rightly, it is better for you to check this article out.
The first step you must know in installing the detector is to turn off the power to the existing light from the breaker box. While you do this process, you have to be sure that the light is off by flipping the switch so you can prevent the bad things that can happen.
For the second step, it is an important for you to remove the screws which hold the old fixture in place. In this case, you must know that the fixture is being attached to the wall so you must be sure to support it with one of your hands. Besides, you must know very well that there is a fixture which will twist off of an independent base. If you own this kind of unit, it is advised for you to remove the screws which hold the base to the wall.
The next step you must know is to use a circuit tester to ensure you that the wires are not live. If you do not know on this tester, it is better for you to concern this condition. If the circuit tester does not light up, it is said that it will be safer for you to proceed. While it does light up, it is also crucial for you to verify that the circuit breaker has disconnected the electricity to the fixture and test again so you can be sure that it will not make you get any problem while the process of installation happens.
For the next step, you must detach the light fixture wires from the electrical service wires in the wall. There are many people who will be attached them with wire nuts because this process is really simple to twist off. Also, it will allow the wires to be untangled. Just be sure that you follow the process rightly so you can install it properly.
