subject: Use common sense Xiangjie pen - ball pen - Office Supplies Industry [print this page] Use common sense Xiangjie pen - ball pen - Office Supplies Industry
Ball point pen Than Pen Durable, but if used properly maintained, often could not write words, this is mainly due to the dried ink oil bond in the ball around the ink outflow obstruction's sake. Ink is a viscous oil, is to use sesame oil, synthetic pine oil (the main content terpenols substances), mineral oil (such as mineral oil fractions obtained from oil), hard plastic fumes, etc., prepared by adding into the .
Use Ball point pen , Do not have oil and wax on paper writing, or oil, wax, steel ball embedded in the copper bowl border effects of oil could not write a word, but also to avoid the pen impact, exposure, not a good time with the gloves cap, to prevent break something written, pen variant and Refill Oil spills and pollutants. In case of cold weather or long home unused. Document no oil, can be written into the warm water soak a while before the stroke nib on the paper, you can write a word.
beads shut up process: written with ball pen and ball seat of beads to explain, the specified bead here, here is the tee, Ink Five communication channels.
Beads into the tee, tee shut, wrap beads, beads Bu Zhiyu the ball fell out to complete the written process.
ball-point pen writing principles: Ball beads are free to rotate within the ball seat. Ball-point pen ink through the ball seat in the grooves of the five beads on the flow of the ball, pen writing, the friction drive ball bead rotation, thus constantly flowing beads of ink on the transfer to the written material.
pen Maoyou reasons Ball-point pen in writing, the part of the ink transfer from the beads to writing material, please watch white beads to be after the transfer, the other part of the ink will turn back to the ball with beads inside the seat.
Well written, with the rotating beads will be back to tee ink more thoroughly, ink stick in the ball socket head out less cleaner.
Poor written, the majority of ink stick in the head outside the tee, the ball can not be brought back seat, that is Maoyou phenomenon, writing, it is easy to write material contamination.
Be fluent pen, ink, the more, but the negative effect of road and more road to small defects is not fluent. Both cases is a contradiction, how comprehensive consideration, so that the best results, it is ball-point pen manufacturing industry study.
pen nib ground conditions caused by bumps
Pen floor, hitting 90 degrees, such as pen, the pen is written not damaged, but shut Department bumps, so that this notch will have a "Maoyou" phenomenon, serious, beads will fall off writing difficulties and so on.
pen to write the correct angle (55 ~ 70 )
Ball-point pen writing, the point of control in 55 to 70 is the most ideal, then, only touch the ball and paper beads (beads is very hard ... ... tungsten carbide or ceramic, it is not easy to wear and tear), do not shut Department access to writing materials, thus ensuring a good writing pen in the state to extend the service life.
writing point of the ball is too small easy to wear seat shut Department (ball seat material for the nickel-platinum copper or stainless steel, easy to wear much more than beads), such as long contact with written materials, even if the written material is paper, tee can not withstand wear and tear, so will cause beads off.
writing, the pad of paper too thick, shut Department access to the paper written, easy to wear off beads, recommended: 0.4 beads can not be replicated; 0.5 beads up replication 1, not more; 0.7 beads Most replication 3-4, not more, preferably 75 when replication writing.
