subject: The way to Droop Kitchen Cupboards [print this page] The way to Droop Kitchen Cupboards The way to Droop Kitchen Cupboards
The toughest half of installing new cupboards within the kitchen is securing the cupboards that hang on the walls. They have to be mounted into the studs behind the wall to be able to handle the load of the cabinet and no matter is being stored inside. The installer conjointly must make certain that the cabinets are perfectly square and level. Hanging the cupboards is usually a job that can need 2 folks, one to hold the cabinet up and one to drive the screws into the wall. You want to begin by preparing the walls on which the cupboards will be installed. Once the recent cabinets are out, repair any half of the wall that can not be covered by the new cupboards and paint. It is better to try to to this whereas there are not any cabinets on the wall than to attempt to go back later and paint when your new cabinets are up. Once the wall is prepared, work out how high you are going to hang the cupboards on the wall. Usually, you will wish to go away regarding twenty inches of area between the underside of the cupboard and the top of the counter. Thus if your base cupboards are 34 inches high, you wish to measure fifty four inches from the floor and create a mark on the wall when your top cupboards can begin and where they will end. Connect a plumb line to the two marks and snap, this can offer you a level line for putting in your cabinets. The bottom can run right up to the line. Now that you've got your level line for installation you want to find the studs within the wall which you may secure the cupboards to. In most homes, studs are placed each sixteen inches on center. There are electronic stud finders that you'll be able to use to search out the studs or you'll be able to use a nail and tap into the wall until you find one. Once you find a single stud, you'll be able to live and mark each 16 inches so you know where the others are. There's one more piece of prep work that needs to be done before you start I hanging the cabinets. Build a T-brace out of a couple of 2x4's to use to prop up the wall cabinets whereas you're fastening the screws. Currently that you're prepared to hold your cabinets, come out the doors and take away any shelves or drawers before putting them into place. Elevate the first cupboard into place and use your brace to prop it up. When the cabinet is lined up with the plumb line, use a power driver to put in one screw on prime and one on bottom. Build certain the cupboard is level with the wall and use shims behind it to create any necessary adjustments. Currently lift the next wall cupboard into place along side the one you just secured to the wall and fasten it with a screw on top and bottom. Create certain the 2 seams meet perfectly and then screw the one cupboard into the other. Now go back and put another screw through the rear of the cabinet into the wall on the top and bottom into a completely different stud within the wall and repeat the process with the remainder of the wall cabinets.
