subject: For Short-circuit The Battery Failure, The Method Is More Effective High-voltage [print this page] First of all, the test voltage to zero, the machine can not start naturally, can not use power when charging (the battery light does not shine).
Disassemble the battery, more or less talk about the situation inside the battery.
Battery in a total of 9 can be placed 18 millimeters in diameter, length 65 mm core CGH18650 models the location of lithium batteries, Panasonic's 22 batteries in parallel, three groups of series (OK, then my new Latitude D620 battery, the same, it appears that is 6), there is a very fine control with a single chip - the protection of the circuit, the circuit to the computer a total of five output contacts, respectively, are negative, the clock and data.
First of all, check the sticky in the battery temperature detection probe (temperature resistance), and temperature protection insurance, are also normal. Test-retest the battery voltage of each group, in which two sets of battery voltage of 3.8V, normal; a battery voltage of 0V, appear to have lapsed. The total battery voltage of 7.6V, then the failure of the battery pack has not yet open, then measuring the internal resistance was very small, almost in a state short-circuit.
First of all, failure to deal with Thinkpad T60 batteries, battery repair based on previous experience, the failure of the battery may not be completely damaged, can be activated through a number of methods, in particular the performance of state for the short-circuit the battery. The voltage of the battery to 0 with one end connected to the circuit board off line to avoid damage to circuit boards in operation. Open-circuit battery voltage after the re-survey, is still 0V, ruled out the possibility of short-circuit boards.
For short-circuit the battery failure, the method is more effective high-voltage electric current moment method, using the old IBM power supply (my back-up power), 16V maximum 3A output string on the multimeter (a tributary of the current file 20A), first negative power supply Even with the battery anode, and cathode power multimeter then red table pen, table pen with black multimeter battery cathode touch, speed, faster as far as possible, the former two degrees to see the multimeter has reached close to the 2A (moment) and the third on only 0.4 A about an immediate stop, measure the battery voltage has been restored to about 3V, the internal battery short-circuit that point has been an instant high-current boil (If you do not damage the battery to stop immediately, even if so, battery life and capacity have been the impact, if conditional, or recommend replacement, but if the replacement, then try to replace the entire battery pack are). However, the batteries need to be a separate charge (if the battery charge of the whole group, this will result in the other two groups had mesenchymal cells), plug in the charger to start charging ammeter to monitor during the charge current to 500mA or so, current for the 3.6AH battery pack is small, but the charger is the charge current is limited and a small current to the xps m1330 battery charge is good for the resumption. After about six hours, the charger showed the battery is already full, continue to re-charge for about two hours, remove the battery, measure voltage has reached 4.2V, with bright halogen bulb in the flashlight (3V, 500mA) to discharge its , bulb sharp discharge current of 700mA, the battery pack that has been basically restored, continue to discharge until the battery voltage down to 3.8V, the purpose of the two groups with the same battery voltage, charging time together so as not to overcharge the Back to the whole battery pack battery circuit welding. Laptop BatteryACER Laptop Battery | Dell Laptop Battery | HP Laptop Battery |TOSHIBA Laptop Battery
