subject: A Variety Of Mechanical Maintenance And Repair Of Tea - Tea Machinery, Tea - Food Industry [print this page] All Tea Machinery Maintenance and Repair All Tea Machinery Maintenance and Repair
With the rapid development of famous tea production, tea processing machinery has been popularized in the majority of tea used. After tea quarter of each year to do a good job all year-end tea processing machinery maintenance and repair, because this is directly related to the mechanical efficiency of the play itself, the length of life and the smooth progress of the coming year, tea production.
A tea rolling machine maintenance and repair
Rolling machine is a more mature structure of the tea processing machinery, used the model 25-type, 30 type and 35 and so heavy hammer pressure in the form of screw-type and single-column two.
Twisting Machine by V-belt transmission power, in the year-end maintenance, it is best to replace the new belt to ensure the normal operation of the coming year. Use of V-belt, the length and type should follow the instructions. Belt wheel groove cross-section model should be the same model to ensure the triangular belt wheel slot in the correct section location. Newly installed V-belt can be slightly higher than the outer rim. New belt installed or at a later operation, its degree should maintain a proper tension, tighten the belt easily damaged, Bearing Easy fever, too loose will result in belt slippage when driving. Under normal circumstances, the belt tensioning degree triangle with the thumb to press about 15 mm is appropriate.
The mechanical gear box and roller bearings may refer to the maintenance of fixation machine maintenance.
2, tea roller fixation machine maintenance and repair
Roller fixing machine is suitable for the continuous fixing operation of green tea, used, 30 types and 40 types of two, the heat source in the form of coal or wood type and electric type. It is the most commonly used tea processing machinery. The maintenance and repair of the following elements:
1, replace the worm gear reducer box of oil, lubricating oil can choose 10, 20 or 30 oil.
2, remove all the friction surface of the dirt, especially the chain and sprocket to cleaning, re-filling oil.
3, the chain if too loose, can first be taken to remove sections of the method of adjustment, if it has severely stretched, it should be replaced. Adjustment and replacement of the chain should pay attention: the chain joints, springs installed the card and the direction of the chain should be running in the same direction, so as to avoid an impact running, jumping, or even collision off.
4, to take apart and wash all the rolling bearing, and filling the new grease, calcium sodium base grease can be used.
5, check whether the stove and smoke leakage, leakage found to smoke should smoke ring roller gear, stoves and chimneys, etc., it was discovered in time damage repair and replacement. Electric models should check the heating pipes for damage, any damage should be replaced.
6, after the restoration of all parts of the whole machine assembly, start running, observe the machine is functioning properly. Appropriate heating roller, and put a small amount of speculation special tea oil, cover the cylinder body to melt the surface, then cut off all Power supply . If necessary, spray paint on the machine looks up, dried with Plastic Paper cover, home dry place preservation.
3, tea multi-frying machine maintenance and repair
Frying machine is a 20th century tea processing in China since the 80's application of a new type of machinery, it is used in fixing flat tea processing, management section, flattened shape and needle tea, Mao Feng tea processing Article workflow management.
Frying machine maintenance can refer to the corresponding method.
Four, tea automatic drying machine maintenance and repair
Automatic drying machine is a more complicated structure of the tea processing machinery.
