subject: Aspects Of The Led Tube Compatible Alternative [print this page] Used in mechanical, optical, electrical and thermal and other aspects of the LED Tube compatible alternative to traditional lighting solutions, lighting source (fluorescent lamps, CFL energy saving lamps, halogen or other incandescent lamp) is an industrial revolution taking place. Commercial, office and residential lighting market calls for improved quality of Led Tube lamps. Although the cost is still the main obstacle to these solutions, but also need to note the following technical issues:
And electrical compatibility with existing infrastructure, particularly in the use of standard wall outlet into the dimmer time.
Shall be screw type shape
Must address the heat issue Led Tube
1.1 compatibility dimmer
Currently, family, hotels, and office lighting control equipment are designed for incandescent lamps installed. Dimming function provided the best way is to use "electricity cut phase" dimmer. This principle is dimmer developed for the incandescent power. From the electrical side, incandescent lamps can be considered as a resistive load.
Electronic lighting sources (such as energy-saving CFL lamps or Led Tube light) the electrical equivalent load is no longer a purely resistive load. So that work on dimmers to produce a big difference. Improper use will cause the system to load malfunction, possible flash is very uncomfortable, and even damage to the fixture or dimmer. This may cause user dissatisfaction, thus postponing the use of Led Tube solutions. Currently, the dimmer is still expensive and difficult to install. Therefore, the introduction of the dimmer is compatible with existing high-quality solutions to promote a commitment to honor LED Tube Lighting Inevitable.
Although the phase cut dimmer types vary, but basically the same principle (ie, cut off some of the power in each cycle, sine wave). This can be achieved through the switch. Switch is turned on, the power to transfer to the load (light bulb). Switch off, not power. By adjusting the switch on time, you can adjust the load of the total energy supply.
