subject: Floor Tile Layout - How To Project The Tile Pattern By Technique Of Dry Laying - Direction Of Layin [print this page] Realistically, you don't want to stop midway through tile laying into wet mortar, otherwise you'll notice that it is drying out before you get the prospect really insert the ground tile. Not solely will this be a waste of materials, the changing consistency of the mortar will build it more troublesome to embed the tile correctly, and ultimately extending your job time.
Once you have got your final dry layout planned, and even have some cuts made ahead of time to speed up the method of tile laying, your next set up of action would be to work out your direction and order of laying. The best method is to work around the perimeters of the space first and leaving at least a two' foot gap to work with in the middle of the ground, finally leading out towards the doorway. This is to avoid being 'boxed-in' to a corner, and possibly having to stand on freshly laid floor tiles to get out of the room.
If you stand on an unsettled tile, you'll push it down additional than necessary into the mortar bed, ensuing in an uneven tiled surface, twisting the tile out of its grout line alignment, and additionally squeezing up excess mortar into your grout lines which will be a nightmare to remove effectively once dried. If this was the case, it'd be best to pop the tile make a copy and lay it once more fresh, but all this will be avoided by initially determining your tile laying direction and sticking with the plan.
Although you'll wish to figure outwards to the direction of the doorway, with this floor tile being the final one laid at the door, this tile should still be the initial projection point from where your floor pattern extends. This foundation floor tile should be placed in its appropriate spot when dry laying, then marked out against the floor by drawing a pencil line around it and then extending the complete layout style from that one spot.
If this tile were to transition the ground to an opposing carpeted floor for example, then allowances should be created earlier to adjust to this transition. It is always easier to chop a bit of carpet than to try and extend it by stretching, so you ought to bear in mind to project this foundation tile further than completely necessary towards the carpeted floor when first marking it in together with your pencil. Never butt it on to where the carpet ends, otherwise you may be in for a major unnecessary headache, which rule should apply to most transitions to perpetually compensate for such a factor and think ahead.
