subject: To Compile: Install The Xenon Lamp Frequently Asked Questions And Answers - Xenon Lights - [print this page] 1, xenon lamp installation FAQ 1, xenon lamp installation FAQ
A: with strict anti-AIDS electrical interference, and various abnormal automatic circuit protection, and all equipped with a separate relay and insurance group dedicated xenon dedicated line, so any product supporting abnormal state electronic ballast will automatically shut off the circuit. Vehicles and will not pose any risk, you can rest assured that use.
2, xenon lamp lights installed for those models?
A: fit H1, H3, H4, H7, 9005,9006,9007 and so on xenon lamp. So almost all of the models can be applied.
3, xenon lights easy to install it?
A: Actually, Xenon lights installed, that is, in the original car headlight bulbs removed and replaced with the type of lamp xenon bulbs, and installation of ballast, while the dust cover on the hole leads to harness and use light bulbs with good water line group on the ring of the hole to be sealed after the installation of relay line group, the installation is very convenient, but for the sake of safety operation proposed by the professional electrician.
4 Xenon lamp bulb waterproof?
A: Xenon lamp bulbs and electronic ballasts have been soaked in water experiments, the HID lamp and ballast are waterproof, customers can rest assured that use. Does not include cottage reliability.
5, asked a lot of car headlight rear cover is closed, what should lead to wiring harness?
A: If the rear cover can be sealed 25MM Reamer hole in the back cover, and then on the lamp cord set with special water-proof cap with holes to fit the rear cover seal.
6, Xenon lights installed on the need to replace the fuse?
A: Xenon lamp bulb in the light of the moment back to produce 2,3-million-volt and high current, the original car's fuse normally 10A, proposed to 15-20A fuse, all with a special line set, since with independent insurance and relays, no damage to change the original car lines, with a relay line group do not need to replace the fuse after.
A: No, if the power supply positive and negative reversed, ballast protection circuit will automatically disconnect the power, not burnt ballast, but not a long time power.
8, xenon lamp light installation, if all models have extracted a large chimney before?
A: No, if a sufficient installation space, can not extract the headlights off.
9, asked how to identify good or bad ballast?
A: First, by international standards, light one second to reach 20%, 4 seconds to reach 80% brightness is a good ballast, and the moment that the brightness of 80% or 4 seconds and not up to standard the brightness of poor quality ballast.
Second, start mode, the start ballast is divided into two, one cold start, is the ballast and the bulbs are in a cooling state lighting; second hot start, is the ballast and the bulbs are in the normal operating temperature is the lighting, this state you do repeatedly continuous switching, normal quality, good lighting ballast, and some ballast lamps appear abnormal, there will be a light bulb does not light a phenomenon. To cut off power to restart. The latter is clearly inferior quality.
3, the current market ballast into two species, split and integrated; split on terms not very easy installation, while technically belong to earlier products.
