subject: Some Tips to Read a Fluke Digital Multimeter [print this page] Some Tips to Read a Fluke Digital Multimeter
A Fluke digital multimeter can perform variety of measurement functions. This device can work well in measuring current, voltage, and resistance. By choosing the correct function on selector knob, you can make and read on the measurement on digital display. The Fluke digital multimeter comes with large digital displays so that this can make the numbers easily to read. Besides, this also makes it much easier than the analog multimeter that makes the measurements by a needle which being deflected across the dial face. For whichever type of the measurement that you need, the Fluke digital multimeter can provide the reading that you are searching for. At this time, this article is going to deliver several tips that will guide you to read Fluke digital multimeter. So, just take a look at the following tips.
The first thing that you have to do is to connect probes to your digital multimeter. Probes are color coded black and red. There are separate jacks that used for measuring current, so you have to make sure that you know the type of measurement that you are going to make when you are plugging in your probes. Also, you need to match the colors between probe banana jacks and the input plugs. After that, you should insert black banana jack into the negative or the common plug, and then insert red banana plug into positive plug.
The second thing that you need to do is to turn on your multimeter. What you have to do is to turn the function dial to the function that you want to use. This digital multimeter has the automatic range circuitry, so what you need to do is to select the function. You can select the current, resistance, or voltage.
The third thing is to touch probes to metal contacts from which you would like to take the measurement. You also keep your hands on plastic insulation part of the probes for safety reasons.
The fourth is to read directly the number on the display of Fluke multimeter. The number is the value which is being measured at the tips of probes. For the voltage, the number will be in the volts. For the current, the number will be in the amperes. For the resistance, the number will be in the ohms. You need to watch the decimal point for the numbers and the values less than one.
Finally, you should remove the probes from measurement source and then turn off the Fluke digital multimeter. Then, you have to write down the measurement if you are worried about forgetting the reading.
