subject: Why Snowboarders Benefit From A Stomp Pad [print this page] The snowboarding stomp pad could be a straightforward, yet powerful improvement to your snow boarding set up. The bottom line is, the stomp pad provides grip for the trailing foot whenever it is not buckled in to the binding. Job done.
Why do snowboarders use them? Any time you jump on a ski-lift, you take your back boot out. When you get off from the ski-lift, you glide off from the chair, or drag-lift, with just the leading boot buckled in to a binding. It truly is more challenging for you to control the board like that - and not just for beginners. You have to strengthen your turning/stopping by getting assistance from your back foot. That is often carried out through pushing towards your back binding, to help hold the trailing boot in in a fixed place.
In what way does a stomp pad help? The top of one's board will have snow upon it; it'll be slippy. It doesn't aid your rear boot with hold. The stomp pad is typically built using a material with good grip, possibly rubber. Otherwise, the formation of the stomp pad should give bits of material to grip-against. A common design is a grid of studs. The primary target is more grip and handling from the back foot.
Where should you place it on your snowboard? It really is personal preference, but the most effective spot is in between the two feet, yet near to the rear binding. The aim is to ensure the back foot can be equally on the stomp pad and next to your rear binding, so you can push against it. Be mindful that you have decided on your location of the rear binding; its never good if you ever attach the stomp pad and next decide you need to shift the placement of the back binding - however the stomp pad is in the way!
Does glue work? The stomp pad really should come with powerful epoxy for sticking to your snowboard, but if it does lose stick, applying some other adhesive to hold it in place is ok. Start by clearing the previous adhesive away, make the location fresh and free of moisture, then stick it down. Obviously, some strong, waterproof glue is going to work best.
You'll be able to get a stomp pad from the majority of snow boarding stores, both in shops and online. They are fairly cheap and there are lots of designs to choose from.
