subject: Tiling techniques [print this page] Tiling techniques Tiling techniques
Years ago nobody could believe how tiling will become such an easy thing to learn and do. The first step in tiling used to be soaking Ceramic tiles in water overnight and then set them in thick mortar, but thin set adhesives and backer board, turned that into an old history, the installation of all kinds of tile and other flooring materials such as laminates and cork became much easier and anybody with average skills will be able to do it correctly and easily. Here is how:
All necessary tools and materials you needed for your installation must be placed in order. As a rule of thumb, buy the best brands without compromising cost. A tool can be used in lots of projects if you learnt not to abuse them, and the best methods of keeping them when not used for long periods. Installation steps are like a stream of ideas that need to be integrated in your mind even before you begin the project. Don't work fast to finish fast, focus on everything you do and how it will affect the next step in order to avoid rebuilding the project from the scratch if a badly done step was irreversible.
To master tiling you can use a couple of pieces of backer board as a practice station. By cutting different angles and shapes, and mixing grout you can practice using tile spacers. Do not try to proceed with the tiling project before you are completely sure that you are comfortable with using all of the different tiling tools needed for installing tile.
Always use a ruler to measure your space and tile. To insure straight lines, many people mention using chalk and a ruler among their best practice tips. Do not take rough figures of lengths and measurements, but ensure taking the correct measurements.
Remember to lay the field tiles and leave them; finish the edges the next day to laying them. This step is required to ensure that tiles are dry when you are finishing them, this is meant to avoid over cutting of edges. Do not rent a cutter during the laying day when you are not using it.
During tile laying part of tiling process, start from the middle of the room, this ensures a fair distribution to the cuts you have to made at the edges of the room. Divide the room into four even squares using a snap line, and work evenly between those four squares.
Thin set mortar should be spread down with a notched trowel and the tiles should be pressed into place, following the snap lines and keeping a 1/4-inch space between them. Lay all the full tiles that will fit, then the wet saw will be your best tool to cut the tiles for the edges.
To learn new methods of earning money online, read this article:
