subject: Killtest IBM i 6.1 Administration 000-976 Practice Exam Questions & Braindumps [print this page] Killtest IBM i 6.1 Administration 000-976 Practice Exam Questions & Braindumps
News from killtest, New IBM certification 000-976 practice exam questions are available now.With Killtest IBM Certification 000-976 test questions, you can clear the exam in the first attempt. Before you decide to take the exam, you should know the exam details. Below are the information.
Number of questions: 87
Time allowed in minutes: 105
Required passing score: 55%
Test languages: English
Note: There are 87 scored items and 6 unscored items.
After you have a good understanding of the 000-976 actual test details, you will have more confidence to take the exam. 000-967 exam is a required one for IBM Certified Advanced Technical Expert - Power Systems with IBM i certification and IBM Certified System Administrator - IBM i 6.1 certification.
Killtest IBM 000-976 real dumps can guarantee you success in the first attempt. If you fail the exam, you only need to send the score report to us. After our confirmation, you can get a full refund, or you can choose to get another same value exam.
An system running IBM i 6.1 has a fibre attached IBM TS3500 (3584). Management has instituted a policy that any tape leaving the data center with application data must be encrypted. Which of the following tape encryption modes is supported?
A. System Managed
B. Library Managed
C. Software Managed
D. Application Managed
Answer: B
Some of the master keys on a system have become corrupted and must be restored. Which of the following correctly describes the restore process?
A. Use the RSTMSTKEY command to retrieve the keys from a SAVSYS backup.
B. Run an abbreviated IBM i install. Change the install options to reload the master keys from backup media.
C. Run the RSTOBJ command for QUSRBRM/Q1AKEYFILE. Then use the Translate Master Key Store File command (TRNCKMKSF) with the *SAVRST option to translate the master key to the system.
D. Check that the Save/Restore master key matches to the value at the time the keys were saved. Use the Add Master Part and Set Master Key (SETMSTKEY) commands to set the *SAVRST master key if needed.
