subject: Key Steps To Install A Garage Door Bottom Seal [print this page] It is not very difficult to protect your own garage door from winter conditions by installing a good garage door bottom seal. These seals are great for almost all seasons, not just winter season. There are a number of items necessary to properly install a seal. Some of these items include a door seal, adhesive, knife, and tape. Below we discuss the various steps you should carefully follow when replacing any kind of garage door bottom seal.
The first thing you need to do is in fact select a seal. Your garage door seal can be composed of various different materials. However, it is strongly advised to obtain one composed of high quality rubber.
The next step is to make certain the garage entrance location is cleaned up. You need to make sure all grime and dirt is removed to ensure your garage door bottom seal will be installed correctly. You can thoroughly clean the spot with a sponge, soap and water. Nevertheless, you must make sure that the actual workspace is dried before continuing to the following steps.
The third step is to actually install the seal. You need to measure how much seal is required to cover the bottom of the garage door. Eliminate any seal that is not needed with a scissor. Add a strong adhesive to the bottom of the garage door and carefully apply the seal. Utilize even pressure to ensure the seal sticks to the bottom of the garage door.
Your fourth and final step would be to test your garage door. You should be in a position to open and close up the door without it getting stuck. You should wait for the adhesive to completely dry before proceeding with this check.
If you execute the four steps above, you will have your new garage door bottom seal installed in less than an hour.
