subject: Now You Can Spend Less Time on Measuring Floor Flatness [print this page] Now You Can Spend Less Time on Measuring Floor Flatness
Measuring floor flatness in the industrial flooring market can be quite a lengthy and labor intensive process. Right here is the normal experience of the contractor who is in charge of floor flatness measurement.
Firstly, he'll be sent to a multiday training session. This is a cost to him in terms of time and energy, and a expense of thousands of dollars to his employer (or himself). Just after sitting through these lessons when he may very well be out producing, he's able to go into the area.
So next, he'll arrive to the industrial floor that he's calibrating flatness on, and take a long chalk line. Commonly, while carrying this out, there could be a number of disruptions, just like messages or calls to make, other contractors to speak with, along with other miscellaneous duties that happen within the construction environment.
Just after pulling the chalk line, and sighting up his run the spot in which he's about to measure the floor flatness he's likely to do one of two things. In many instances, he's likely to measure the floor flatness by twisting a tool coming from point to point, and taking a reading.
Regardless of whether he's the quickest guy on earth, this is going to take some considerable time. If he's slow and taking his time, making sure that his floor flatness measurements are very precise this will likely be a really long-drawn-out, labor demanding task.
In some cases, the chalk line remainsand the contractor is going to pull his machine throughout the floor at a steady pace to obtain his floor flatness measurements. This is also lengthy, and labor extensive.
Tasks that cannot be achieved while doing this measurement consist of: Answering and responding to calls; responding to emails if you are using a smart phone or Blackberry; working with other contractors on location and processing reports and other necessary paperwork.
And to be completely straight with you, you cannot even have a smoke break or a snack break while you're out there doing the slow-moving, wearisome physical work. It appears that there should be a better way to accomplish the floor flatness measurement than this.
Compare this experience with the experience of the contractor who works by using as FloorPro floor flatness profiler. Unlike the other two scenarios, the operator of the FloorPro is not tethered to his equipment.
He does not begin by running a chalk line across a lengthy run to be assessed. Instead, he basically sets a piece of reflective tape on the other end of the building, and place up a laser. Next, once the sight is in spot, he hits only one button, and the FloorPro starts to move.
The FloorPro is taking floor flatness measurements, on auto-pilot, at this time.
There was no costly training session. There was no labor intensive chalk line. There's virtually no time spent pulling a machine over the ground. In reality, it was really easy that it almost felt like cheating. But it wasn't. It was performing smart to get the same floor flatness measurements that the industry demands.
At that time that it took to calculate this floor, our contractor was responding to phone calls, interacting with other contractors, and getting more donethe other guys were still strolling their device over the floor.
