Board logo

subject: Do not panic right notebook water treatment! - Notebook water, treatment methods - education sector [print this page]


Do not panic right notebook water treatment! - Notebook water, treatment methods - education sector

We all know, the same configuration Notebook Prices are far higher than Desktops And Notebook Computer Degree of precision comparable non-desktop computers, so, once into the water, the consequences would be disastrous. Range from not working properly, heavy, not enough time to disconnect the power immediately will cause a short circuit, burn out parts, so save the books hard scrap.

Why not let your lovely books stained with a drop of water (some people say that this is not bullshit you, fool it so dry it). If you are not careful, actually make notebooks into the water, no matter what water (purified water, tea, water, juice, drink something, etc.), the notebook is so sophisticated appliances may have been fatal. Remember, at this time no matter what program you're running, no matter who is talking to and warming up, it should immediately disconnect the power plug, remove Battery , Can not use normal shutdown, so too late, once the notebook upside down, so that most of the water flow out first, and then get some absorbent paper notebook out of the water, first dry, waiting for further processing. Do not trusting to luck, that does not matter, even now no problems, then maybe one day the problem will find the door, then, may regret later.

In general, the advanced parts of water are mostly keyboard, LCD screen is not very big possibility of water. If too much water would likely flow down the keyboard on the motherboard. Next we get the right screwdriver that tools such as the notebook open for further examination. The structure of different types of notebook are very similar to first remove the keyboard, carefully observe the observation, as long as the twisted trunk and a few screws on the line. Removed to the future, you can see the motherboard, look board has no water, if water, it can start sucking the water with absorbent paper and then use the medical cotton ball dipped in ethanol (do not puncture the skin with a sterile hospital that, that is diluted with water 75% off) and gently wipe the board, if again not work, you can clean it repeatedly 2-3 times. Must not use water, because no matter what it is all fresh water contains a certain chemical substances, a long time, will board the corrosion off, the same notebook will scrap. Because ethanol has a full-volatile, let it air dry after wiping off as well.

Board then cleaned the keyboard after the open, as long as the laptop into the water, the keyboard is the first victim. Cleaning the keyboard and motherboard is almost equally with anhydrous alcohol, but the notebook keyboard to open the screw a little more, spend more time Bale.

All washed, dried after the various components can be in reverse order in accordance with the original installation is good, it restitution. This time we can power test machine, I believe you will succeed.

After this treatment after the general will not have any problems, this is just an amateur that we can do under the conditions, if you still do not trust, then you can point to specific service stations, and using ultrasonic cleaning instrument cleaning, cleaning effect as a little more thoroughly.




welcome to loan (http://www.yloan.com/) Powered by Discuz! 5.5.0