subject: Charge must be a full, otherwise it will damage the battery [print this page] Charge must be a full, otherwise it will damage the battery
Charge must be a full, otherwise it will damage the battery laptop battery ACER Laptop Battery . This is based on the reduced charge to avoid the charge with a periodic increase in the number of shortened battery life; rather than as "memory feature" issue, lithium batteries, unlike nickel-cadmium batteries and nickel-hydrogen batteries have "memory characteristics", lithium batteries do not have "memory characteristics. "
Such as charging the machine is turned off or sleep mode, when charging to 3 ~ 4 hours after the green power status light is no longer beating, this time has reached 100% capacity, shall promptly remove the AC power plug to prevent overcharge and cause the battery damage battery.
If the machine is charging, wait, hang or side edge with a state charge, then when the charge to 3 to 4 hours after the green power status light is no longer beating, the battery charge status is automatically out .
Charging process will carry out a rapid charge, then the power status indicator is amber (Always), charge to a certain value into the Juan thin current slow charge, then the power status light flashes green the color becomes ; has been full of 100% after, it becomes green (Always) a. Lithium battery charging method is constant pressure to start charging voltage that will soon stabilize, but the current is getting smaller and smaller.
3. Power is not fully depleted before (ie electricity from 5 to 100%), not to charge the battery, otherwise they will reduce the charge to increase with cycle number of charge cycles and shorten battery life.
When the power is 5 ~ 95% battery should be used, so the use of AC power adapter will charge the battery (side with the state of charge side ).
4. When the power is 96 ~ 100% or the battery removed from the machine can boot using the AC power adapter to run, please use the AC power adapter, AC power adapter into the DC output plug into the machine, and then the AC power plug into 220V ~ socket; remove the AC power adapter, unplug the AC power cord should be first and then disconnect from the machine on AC power adapter's DC output plug. Otherwise you may damage the equipment.
