subject: Orchid Propagation - Three Common Methods [print this page] Orchid Propagation - Three Common Methods
Before we go into how to propagate orchids it is of interest to know that orchid propagation can add much fun and pleasure to a growing orchids hobby.
Orchids come in many different sizes, shapes, and colors and are widely found typically in many tropical areas around the globe. As orchids have risen in popularity, because of their many variations of exotic, gorgeous flowers, many orchid growers have developed different approaches to propagate them.
Orchid propagation encompasses all methods used to reproduce and multiply orchids. There are various ways to produce new orchids from old ones, since plants are innately set up to reproduce. Some methods can be applied by most growers while others are too complicated and can only be accomplished within laboratory type conditions.
Here are three commonly used methods for orchid propagation:
Division: This is the most used and the simplest at-home method of orchid propagation typically done during repotting in the early spring just as the new growth begins. Division simply means taking a mature plant and splitting the root system into two or more parts each with at least one new sprout. By doing so, each of the new plants will usually develop into a properly flowering good sized orchid plant that will thrive just like the original one and will be able to bloom the following season. If this method is used, make sure to divide the plants only if each division will have at least three back bulbs and each division has at least one new apparent growth tip.
Cuttings: The cutting method is another one of the easiest methods that allow orchids to propagate. However, the how varies depending on the orchid type to be propagated. If it's an epiphytic orchid, the plant aerial roots will be scattered along the stem so the plants should be cut at the stem below the roots. Replant the cutting in a small pot and filled with growing medium covering the roots which will stabilize the cutting in position in the pot. If the plant is a terrestrial or ground based plant, the cutting procedure is different. When terrestrial orchid plants are ready for new growth, they form pseudo bulbs that sprout the new growth. Cut one of these pseudo bulbs with some healthy roots attached from the old plant. Then, replant it in a small pot with roots pointing down and slowly pack with potting mix until roots are fully covered but with the pseudo bulbs above the potting medium.
Seeds: Orchids, unlike many other plants have dust-like seeds. To manage this task it requires special equipment and for the work to be done in an sterile environment. This approach is applicable really only for the professionals who have access to a laboratory type set up.
Orchid propagation by division or cuttings may not seem like too much of a task but it is important to educate yourself on the best propagating method for your type of orchids and the requirements needed to make it a success. Once you have an idea which method of orchid propagation is the most suitable method to multiply your orchid plants you will enjoy the process and the results.
