I have some ideas for you to achieve much better results with the device using your embroidery threads in sewing of embroidery.
one. If it detects wire breakage or had completed the styles of bleeding on your clothes just after money, you will most likely continue to use rayon thread! The polyester embroidery thread is stronger and more colorfast. Generally, getting rid of embroidered clothes in the washer immediately, this can help get rid of bleeding. To avoid breakage, any evidence of tension, rayon threads are the weakest of the embroidery yarn.
I've been using an industrial polyester yarn, embroidery thread ARC for more than a year, and get wonderful results. By no means a break and wash well the time just after the hour. Embroidery is still amazing, even right after the garment is used. The curve thread currently has 288 colors!
Second If you find a heavy structure up in the back of similar styles, try to exploit the only pre-wound bobbin that works flawlessly on our machines. They are precision wound with 132 yards through the coil, continuous filament polyester that runs with less lint. They not only reduce the amount of building, I have to clean my drive so often!
Three. If you have set up using metallic thread because of the violation, together with other difficulties that are typical of the metal has not shown even bigger! In my opinion there is only one cash I will invest my time application - Monday to Rex industrial grade wire. It is an exact weight of 40. & Lubricants not require special or different values of normal voltage. I'm not using a special needle either! It comes in beautiful colors from 1000 to 1080 cones 21 yd.
"Other" brands you can try the following:
one. Normally wire feeding on the cone / spool or strain will.
Second Lower the upper tension.
Three. Use a larger eye needle or metallic needle.
Fourth not use any lubricant on the machines - that will ruin our hard automatic voltage!
